reassign 426284 installation-reports thanks On Sunday 27 May 2007 19:11, Toni Mueller wrote: > using the official i386 installer CD #1 in expert mode, I am unable to
I guess you mean the official Etch installer? > create RAID devices using the menues. When I'm in the partitioner, I > create identical "physical RAID volume" layouts for my (two SATA) > disks, recognized as sd2 and sd3, then go to "Configure Software RAID", sd2 and sd3? Sounds very unlikely as disks are named sda, sdb, sdc, etc. > then say "create MD device", enter appropriate parameters, then say > "finish", and then nothing happened. No RAID device is shown in the > partition list, and I cannot exit the partitioner because I "have no > root device". This functionality has been tested fairly extensively and is known to generally work. From the short description of the "appropriate parameters" we cannot determine if this is a real issue or an error in the use of the partitioner by you. Please provide: - the output of 'fdisk -l' for both disks just _after_ the point where you select "configure software RAID" and have confirmed that you want to write pending changes to the partition table - a verbose description of the dialogs you see after choosing "configure software RAID" and the choices you make c.q. values you enter Cheers, FJP -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
