Package: firmware-atheros Version: 0.43
The ar3k/AthrBT_0x31010000.dfu patch seemingly does not load and as a result bluetooth is not available using this driver. The message [ 28.834522] usb 3-7: firmware: failed to load ar3k/AthrBT_0x31010000.dfu (-2) [ 28.834523] usb 3-7: Direct firmware load failed with error -2 shows during boot then no bluetooth hardware is found by Gnome 3 or Cinnamon. Kernel log: Dec 8 15:06:20 debian kernel: [ 28.572735] ath: phy0: WB335 2-ANT card detected Dec 8 15:06:20 debian kernel: [ 28.572738] ath: phy0: Set BT/WLAN RX diversity capability Dec 8 15:06:20 debian kernel: [ 28.579818] ath: phy0: Enable LNA combining Dec 8 15:06:20 debian kernel: [ 28.580982] ath: phy0: ASPM enabled: 0x42 Dec 8 15:06:20 debian kernel: [ 28.580983] ath: EEPROM regdomain: 0x65 Dec 8 15:06:20 debian kernel: [ 28.580984] ath: EEPROM indicates we should expect a direct regpair map Dec 8 15:06:20 debian kernel: [ 28.580985] ath: Country alpha2 being used: 00 Dec 8 15:06:20 debian kernel: [ 28.580986] ath: Regpair used: 0x65 Dec 8 15:06:20 debian kernel: [ 28.592297] Bluetooth: Core ver 2.19 Dec 8 15:06:20 debian kernel: [ 28.592308] NET: Registered protocol family 31 Dec 8 15:06:20 debian kernel: [ 28.592309] Bluetooth: HCI device and connection manager initialized Dec 8 15:06:20 debian kernel: [ 28.592315] Bluetooth: HCI socket layer initialized Dec 8 15:06:20 debian kernel: [ 28.592317] Bluetooth: L2CAP socket layer initialized Dec 8 15:06:20 debian kernel: [ 28.592323] Bluetooth: SCO socket layer initialized Dec 8 15:06:20 debian kernel: [ 28.602165] ieee80211 phy0: Selected rate control algorithm 'minstrel_ht' Dec 8 15:06:20 debian kernel: [ 28.602342] ieee80211 phy0: Atheros AR9565 Rev:1 mem=0xffffc90010f80000, irq=17 Dec 8 15:06:20 debian kernel: [ 28.671334] Adding 13672444k swap on /dev/mapper/volumes-swap. Priority:-1 extents:1 across:13672444k FS Dec 8 15:06:20 debian kernel: [ 28.785125] fbcon: inteldrmfb (fb0) is primary device Dec 8 15:06:20 debian kernel: [ 28.803812] usbcore: registered new interface driver btusb Dec 8 15:06:20 debian kernel: [ 28.834522] usb 3-7: firmware: failed to load ar3k/AthrBT_0x31010000.dfu (-2) Dec 8 15:06:20 debian kernel: [ 28.834523] usb 3-7: Direct firmware load failed with error -2 Dec 8 15:06:20 debian kernel: [ 28.834524] usb 3-7: Falling back to user helper Dec 8 15:06:20 debian kernel: [ 28.834878] Bluetooth: Loading patch file failed Dec 8 15:06:20 debian kernel: [ 28.834881] ath3k: probe of 3-7:1.0 failed with error -12 System Info: Linux debian 3.16.0-4-amd64 #1 SMP Debian 3.16.7-ckt2-1 (2014-12-08) x86_64 GNU/Linux Debian/testing up to date Hopefully relevant hw info: *-usbhost:0 product: xHCI Host Controller vendor: Linux 3.16.0-4-amd64 xhci_hcd physical id: 0 bus info: usb@4 logical name: usb4 version: 3.16 capabilities: usb-3.00 configuration: driver=hub slots=4 speed=5000Mbit/s *-usbhost:1 product: xHCI Host Controller vendor: Linux 3.16.0-4-amd64 xhci_hcd physical id: 1 bus info: usb@3 logical name: usb3 version: 3.16 capabilities: usb-2.00 configuration: driver=hub slots=14 speed=480Mbit/s *-usb:0 description: Video product: Lenovo EasyCamera vendor: CF0D9SMDX physical id: 4 bus info: usb@3:4 version: 0.09 serial: 200901010001 capabilities: usb-2.00 configuration: driver=uvcvideo maxpower=500mA speed=480Mbit/s *-usb:1 UNCLAIMED description: Bluetooth wireless interface vendor: Atheros Communications, Inc. physical id: 7 bus info: usb@3:7 version: 0.01 capabilities: bluetooth usb-1.10 configuration: maxpower=100mA speed=12Mbit/s *-usb:2 description: Generic USB device product: USB2.0-CRW vendor: Generic physical id: 8 bus info: usb@3:8 version: 39.60 serial: 20100201396000000 capabilities: usb-2.00 configuration: driver=rtsx_usb maxpower=500mA speed=480Mbit/s