On Thu, Dec 27, 2018 at 08:05:08AM +0100, Bernhard wrote: > > I made a test with a pre-built image from banana-pi.org. > This is Debian 8 "Jessie" with a very old kernel 3.4. > I assume, the famous sunxi-kernel. > Here, the Ethernet works. > The complete log during booting is attached. > Hopefully, it helps. > > If i can do further tests, or if you need further informations: please let me > know. > > Best regards > Bernhard >
> HELLO! BOOT0 is starting! <snip/> > [ 1.308][mmc]: mmc not find,so not exit > HELLO! BOOT0 is starting! <snip/> > U-Boot 2011.09-rc1-00000-g4948cb4-dirty (Jul 11 2018 - 01:55:24) Allwinner > Technology <snip/> > ** Invalid boot device ** > [ 4.579][mmc]: blkcnt should not be 0 > Loaded environment from uEnv.txt > Running uenvcmd ... > Banana Pi bpi-m3 chip: a83t Service: linux bpiuser: 720p > [ 5.131][mmc]: blkcnt should not be 0 > ## Booting kernel from Legacy Image at 48000000 ... > Image Name: Linux-3.4.39-BPI-M3-Kernel > Image Type: ARM Linux Kernel Image (uncompressed) > Data Size: 7002512 Bytes = 6.7 MiB > Load Address: 40008000 > Entry Point: 40008000 > Verifying Checksum ... OK > ## Loading init Ramdisk from Legacy Image at 43100000 ... > Image Name: uInitrd > Image Type: ARM Linux RAMDisk Image (gzip compressed) > Data Size: 5161148 Bytes = 4.9 MiB > Load Address: 00000000 > Entry Point: 00000000 > Verifying Checksum ... OK > Loading Kernel Image ... OK > OK > [ 5.327][mmc]: MMC Device 2 not found > [ 5.331][mmc]: mmc not find,so not exit > [ 5.335] > Starting kernel ... > > [sun8i_fixup]: From boot, get meminfo: > Start: 0x40000000 > Size: 2048MB > ion_carveout reserve: 96m 128m > ion_reserve_common: ion reserve: [0xb8000000, 0xc0000000]! > ion_cma reserve: 120m 176m 512m > ion_reserve_common: ion reserve: [0xa0000000, 0xc0000000]! > ------sun8i_smp_init_ops----37----- > [ 0.000000] Booting Linux on physical CPU 0 > [ 0.000000] Initializing cgroup subsys cpuset > [ 0.000000] Initializing cgroup subsys cpu > [ 0.000000] Linux version 3.4.39-BPI-M3-Kernel (root@1a557e1c594c) (gcc > version 4.6.3 (Ubuntu/Linaro 4.6.3-1ubuntu5) ) #3 SMP PREEMPT Wed Jul 11 > 01:55:51 UTC 2018 > [ 0.000000] CPU: ARMv7 Processor [410fc075] revision 5 (ARMv7), cr=10c5387d <snip/> > [ 2.320816] [rfkill]: mod has no ls_int gpio > [ 2.320830] [rfkill]: mod has no pcm_ch gpio > [ 2.321375] [rfkill]: rfkill set power 0 <snip/> > [ 17.939254] systemd[1]: Detected architecture arm. > > Welcome to [1mDebian GNU/Linux 9 (stretch)[0m! > > [ 17.982068] systemd[1]: Set hostname to <bpi-iot-ros-ai>. <snip/> > [ 26.486354] USB Serial support registered for GSM modem (1-port) > [[0;32m OK [0m] Started Set console font and keymap. > [[0;32m OK [0m] Found device /dev/ttyS0. > [[0;32m OK [0m] Listening on Load/Save RF Kill Switch Status /dev/rfkill > Watch. > [[0;32m OK [0m] Reached target Sound Card. > Starting Create Volatile Files and Directories... > Starting Load/Save RF Kill Switch Status... > [ 29.552854] gmac0: probed > [ 29.600398] gmac0 gmac0: eth0: eth0: PHY ID 001cc915 at 0 IRQ poll > (gmac0-0:00) > [ 29.700631] [rfkill]: rfkill set power 0 > [[0;32m OK [0m] Started Create Volatile Files and Directories. > [[0;32m OK [0m] Started Load/Save RF Kill Switch Status. <snip/> > [ 33.600389] PHY: gmac0-0:00 - Link is Up - 100/Full > Starting Network Manager... > Starting Accounts Service... <snip/> > [ 54.107624] rc.local[780]: My IP address is 192.168.2.150 > 2003:ca:bf4:5814:1842:4bff:fe49:9561 > Starting User Manager for UID 1000... <snip/> > Debian GNU/Linux 9 bpi-iot-ros-ai ttyS0 > > bpi-iot-ros-ai login: For some reason I assume that `RF Kill` does more then just wireless. I don't know which way to go. Too many options. Groeten Geert Stappers -- Leven en laten leven