Package: pilot-link
Version: 0.12.1-5
Severity: important
I have a Palm m100. When I attempt a direct serial hotsync, it
fails. The Palm displays this message:
HotSync Problem
The connection between your handheld computer and the desktop was
lost. Some of your data was NOT backedc up. Please check your
setup and try again.
The messages I see in my xterm are:
-anarres:d> PILOTPORT=/dev/pilot1 /usr/bin/pilot-xfer -b .
Listening for incoming connection on /dev/pilot1... connected!
Error read system info on /dev/pilot1
The `connected!' happens when I press the hotsync button on my sync
cable. The `Error' happens some seconds after the failure.
It works fine with the pilot-link package from sarge; even sarge's
pilot-xfer binary run under etch works fine too.
Ian.
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
