Package: wodim
Version: 9:1.1.2-1
Severity: important
I have an internal CD Writer which writes to CDs fine. However my
external DVD writer fails to write CDs.
The drive is connected to a USB port.
Here is the device turning on in the kernel logs:
[69634.722813] usb 5-4: new high speed USB device using ehci_hcd and
address 4
[69634.847748] usb 5-4: configuration #1 chosen from 1 choice
[69635.608307] Initializing USB Mass Storage driver...
[69635.616006] scsi2 : SCSI emulation for USB Mass Storage devices
[69635.617858] usb-storage: device found at 4
[69635.617868] usb-storage: waiting for device to settle before scanning
[69635.618520] usbcore: registered new interface driver usb-storage
[69635.618666] USB Mass Storage support registered.
[69640.620282] scsi 2:0:0:0: CD-ROM _NEC DVD_RW ND-1300A
1.08 PQ: 0 ANSI: 0
[69640.628400] usb-storage: device scan complete
[69642.068482] sr0: scsi3-mmc drive: 40x/40x writer cd/rw xa/form2 cdda
tray
[69642.071128] sr 2:0:0:0: Attached scsi CD-ROM sr0
[69642.224080] sd 0:0:0:0: Attached scsi generic sg0 type 0
[69642.226523] sr 2:0:0:0: Attached scsi generic sg1 type 5
Here is the output from lsusb -vv:
Bus 005 Device 004: ID 05e3:0701 Genesys Logic, Inc. USB 2.0 IDE Adapter
Device Descriptor:
bLength 18
bDescriptorType 1
bcdUSB 2.00
bDeviceClass 0 (Defined at Interface level)
bDeviceSubClass 0
bDeviceProtocol 0
bMaxPacketSize0 64
idVendor 0x05e3 Genesys Logic, Inc.
idProduct 0x0701 USB 2.0 IDE Adapter
bcdDevice 0.02
iManufacturer 2
iProduct 3
iSerial 0
bNumConfigurations 1
Configuration Descriptor:
bLength 9
bDescriptorType 2
wTotalLength 32
bNumInterfaces 1
bConfigurationValue 1
iConfiguration 0
bmAttributes 0xc0
Self Powered
MaxPower 4mA
Interface Descriptor:
bLength 9
bDescriptorType 4
bInterfaceNumber 0
bAlternateSetting 0
bNumEndpoints 2
bInterfaceClass 8 Mass Storage
bInterfaceSubClass 2 SFF-8020i, MMC-2 (ATAPI)
bInterfaceProtocol 80
iInterface 0
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x81 EP 1 IN
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0200 1x 512 bytes
bInterval 1
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x02 EP 2 OUT
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0200 1x 512 bytes
bInterval 1
Here is the output from k3b:
System
-----------------------
K3b Version: 0.12.17
KDE Version: 3.5.5
QT Version: 3.3.7
Kernel: 2.6.20-rc3linusdccp
Devices
-----------------------
_NEC DVD_RW ND-1300A 1.08 (/dev/scd0, /dev/sg1) at [CD-R; CD-RW;
CD-ROM; DVD-ROM; DVD-R; DVD-RW; DVD+R; DVD+RW] [DVD-ROM; DVD-R
Sequential; DVD-RW Restricted Overwrite; DVD-RW Sequential; DVD+RW;
DVD+R; CD-ROM; CD-R; CD-RW] [SAO; TAO; RAW; SAO/R96P; SAO/R96R; RAW/R16;
RAW/R96P; RAW/R96R; Restricted Overwrite]
LG CD-ROM CRD-8482B 1.05 (/dev/hdc, ) at /media/cdrom0 [CD-ROM] [Error]
[None]
CyberDrv CW099D CD-R/RW 120M (/dev/hdd, ) at /media/cdrom1 [CD-R; CD-RW;
CD-ROM] [CD-ROM; CD-R; CD-RW] [SAO; TAO; RAW; SAO/R96P; SAO/R96R;
RAW/R16; RAW/R96P; RAW/R96R]
K3b
-----------------------
Size of filesystem calculated: 473
Used versions
-----------------------
cdrecord: 2.1.1a03
cdrecord
-----------------------
scsidev: '2,0,0'
scsibus: 2 target: 0 lun: 0
Linux sg driver version: 3.5.34
Wodim version: 1.1.2
SCSI buffer size: 64512
Beginning DMA speed test. Set CDR_NODMATEST environment variable if
device
communication breaks or freezes immediately after that.
TOC Type: 3 = CD-ROM XA mode 2
Waiting for data on stdin...
Driveropts: 'burnfree'
atapi: 1
Device type : Removable CD-ROM
Version : 0
Response Format: 2
Capabilities :
Vendor_info : '_NEC '
Identification : 'DVD_RW ND-1300A '
Revision : '1.08'
Device seems to be: Generic mmc2 DVD-R/DVD-RW.
Current: 0x000A (CD-RW)
Profile: 0x001B (DVD+R)
Profile: 0x001A (DVD+RW)
Profile: 0x0014 (DVD-RW sequential recording)
Profile: 0x0013 (DVD-RW restricted overwrite)
Profile: 0x0011 (DVD-R sequential recording)
Profile: 0x0010 (DVD-ROM)
Profile: 0x000A (CD-RW) (current)
Profile: 0x0009 (CD-R)
Profile: 0x0008 (CD-ROM) (current)
Using generic SCSI-3/mmc CD-R/CD-RW driver (mmc_cdr).
Driver flags : MMC-3 SWABAUDIO BURNFREE
Supported modes: TAO PACKET SAO SAO/R96R RAW/R96R
Drive buf size : 1345536 = 1314 KB
FIFO size : 12582912 = 12288 KB
Speed set to 1764 KB/s
Track 01: data 0 MB
Total size: 1 MB (00:06.33) = 475 sectors
Lout start: 1 MB (00:08/25) = 475 sectors
Current Secsize: 2048
ATIP info from disk:
Indicated writing power: 3
Reference speed: 6
Is not unrestricted
Is erasable
Disk sub type: High speed Rewritable (CAV) media (1)
ATIP start of lead in: -11635 (97:26/65)
ATIP start of lead out: 337350 (75:00/00)
1T speed low: 4 1T speed high: 10
2T speed low: 4 2T speed high: 0 (reserved val 6)
power mult factor: 1 5
recommended erase/write power: 5
A1 values: 24 1A D8
A2 values: 26 B2 4A
Disk type: Phase change
Manuf. index: 3
Manufacturer: CMC Magnetics Corporation
Blocks total: 337350 Blocks current: 271473
Blocks remaining: 270998
Starting to write CD/DVD at speed 10.0 in
real TAO mode for multi session.
Last chance to quit, starting real write in 2
seconds.
1 seconds.
0 seconds. Operation starts.
Waiting for reader process to fill input
buffer ... input buffer ready.
Performing OPC...
Starting new track at sector: 65877
Track 02: 0 of 0 MB written.
Errno: 12 (Cannot allocate memory),
write_g1 scsi sendcmd: no error
CDB: 2A 00 00 01 01 55 00 00 1F 00
status: 0x0 (GOOD STATUS)
cmd finished after 0.000s timeout 40s
/usr/bin/X11/wodim: A write error
occured.
/usr/bin/X11/wodim: Please properly read
the error message above.
write track data: error after 0 bytes
Writing time: 7.600s
Average write speed 1.2x.
Fixating...
Errno: 5 (Input/output error), close
track/session scsi sendcmd: no error
CDB: 5B 00 02 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 05 00 00 00 00 0A 00
00 00 00 72 04 00 00
Sense Key: 0x5 Illegal Request, Segment
0
Sense Code: 0x72 Qual 0x04 (empty or
partially written reserved track) Fru
0x0
Sense flags: Blk 0 (not valid)
cmd finished after 0.002s timeout 480s
cmd finished after 0.002s timeout 480s
Fixating time: 0.006s
/usr/bin/X11/wodim: Cannot fixate disk.
BURN-Free was never needed.
cdrecord command:
-----------------------
/usr/bin/X11/wodim -v gracetime=2
dev=2,0,0 speed=10 -tao
driveropts=burnfree -eject -multi -waiti
-xa -tsize=473s -
mkisofs
-----------------------
Rock Ridge signatures found
Rock Ridge signatures found
473
I: -input-charset not specified, using
iso-8859-1 (detected in locale settings)
Rock Ridge signatures found
Total translation table size: 0
Total rockridge attributes bytes: 69288
Total directory bytes: 309248
Path table size(bytes): 1926
Max brk space used 83000
66350 extents written (129 MB)
mkisofs command:
-----------------------
/usr/bin/X11/genisoimage
-cdrecord-params 0,65877 -prev-session
/dev/scd0 -gui -graft-points -volid K3b
data project -volset -appid K3B THE CD
KREATOR (C) 1998-2005 SEBASTIAN TRUEG
AND THE K3B TEAM -publisher -preparer
-sysid LINUX -volset-size 1
-volset-seqno 1 -sort
/tmp/kde-ian/k3bp83rca.tmp
-rational-rock -hide-list
/tmp/kde-ian/k3bhjLpna.tmp -joliet
-hide-joliet-list
/tmp/kde-ian/k3bF9nPrb.tmp
-full-iso9660-filenames -iso-level 2
-path-list /tmp/kde-ian/k3baZi8pa.tmp
msinfo
-----------------------
0,65877
msinfo command:
-----------------------
/usr/bin/X11/wodim dev=2,0,0 -msinfo
-- System Information:
Debian Release: 4.0
APT prefers unstable
APT policy: (500, 'unstable')
Architecture: i386 (i686)
Shell: /bin/sh linked to /bin/bash
Kernel: Linux 2.6.20-rc3linusdccp
Locale: LANG=en_NZ, LC_CTYPE=en_NZ (charmap=ISO-8859-1)
Versions of packages wodim depends on:
ii libc6 2.3.6.ds1-10 GNU C Library: Shared libraries
ii libcap1 1:1.10-14 support for getting/setting POSIX.
Versions of packages wodim recommends:
ii genisoimage 9:1.1.2-1 Creates ISO-9660 CD-ROM filesystem
-- no debconf information
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
