Package: installation-reports Boot method: CD Image version: Lenny businesscard ISO dated 27/12/07 Date: 05 March 2008 Machine: home built on AsRock K7VT4APRO (BIOS v1.70) Processor: AMD Sempron2600+ (1.83GHz) Memory: 1GB Partitions: 2xWD7500AAKS (750GB) sda1: 20GB sdb1: 20GB sda2: 1GB /boot sdb2: 1GB swap sda3: 729GB sdb3: 729GB md0: 20GB RAID1 (sda1+sdb1) / md1: 729GB RAID1 (sda3+sdb3) LVM VG0 LV0: 10GB /var LV1: 10GB /usr/local LV2: 20GB /home LV3: 689GB /archive
Base System Installation Checklist: [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Initial boot: [O] Detect network card: [O] Configure network: [O] Detect CD: [O] Load installer modules: [O] Detect hard drives: [O] Partition hard drives: [O] Install base system: [O] Clock/timezone setup: [O] User/password setup: [E] Install tasks: [O] Install boot loader: [O] Overall install: [O] Comments/Problems: Sorry to use an out-of-date installer image. The 03/03/08 installer is on my USB fob, but the machine would not boot from it (I think because I had formatted the USB stick as a hard disk rather than as a "superfloppy"). Thought it worth submitting this report anyway, because of the root login issue. The installer detected both NICs and asked me to choose one as primary. It then configured that interface successfully, but did not offer to configure the other NIC. It would be nice (as in wishlist) if it offered to configure any remaining interfaces. At user setup I was offered the opportunity to disable root logins and use sudo instead, and I chose to do so. I then created my userID (chrisc) and set my password. I then installed the boot loader, finished the install successfully and rebooted. On rebooting, user chrisc did not exist, and user root could log in with no password!! Oops. Once I logged in as root (and set a root password) I confirmed that user chrisc had not been created. The sudo package had not been installed either. Regards, CC This e-mail may contain information which is confidential, legally privileged and/or copyright protected. This e-mail is intended for the addressee only. If you receive this in error, please contact the sender and delete the material from your computer
