Tormod Volden wrote:
> Thanks for your bug report. I am not surprised there are issues with
> R128 cards since they are not Radeon cards. But since it worked with
> 1.5-5 we should be able to figure it out. As you saw, the scanning for
> the card memory ranges has changed from using lspci to internal
> parsing, and the detection logic is different.
Yes. I wanted to bisect, but I couldn’t find a git repo incorporating
the old version. I hope to make one collecting the tarballs I could
find this weekend.
> Can you please give the
> output from: lspci -vvnn -d 1002:
Attached.
Thanks,
Jonathan
01:00.0 VGA compatible controller [0300]: ATI Technologies Inc Rage Mobility M3
AGP 2x [1002:4c46] (rev 02) (prog-if 00 [VGA controller])
Subsystem: Dell Device [1028:00b0]
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping+ SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 32 (2000ns min), Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 11
Region 0: Memory at f8000000 (32-bit, prefetchable) [size=64M]
Region 1: I/O ports at ec00 [size=256]
Region 2: Memory at fdffc000 (32-bit, non-prefetchable) [size=16K]
[virtual] Expansion ROM at fd000000 [disabled] [size=128K]
Capabilities: [50] AGP version 2.0
Status: RQ=32 Iso- ArqSz=0 Cal=0 SBA+ ITACoh- GART64- HTrans-
64bit- FW- AGP3- Rate=x1,x2
Command: RQ=1 ArqSz=0 Cal=0 SBA+ AGP- GART64- 64bit- FW-
Rate=<none>
Capabilities: [5c] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-
