Hi Frank
I have not read all the configs you sent yet, but a few things:
you might want to blank out your public address when sending configs to mailing
lists
can you give the output of this
for i in raw mangle filter nat
do echo -e "\n\n$i:"; iptables -t $i -nvL
done
this will show the config for all the tables and in a little more detail
also your firewall appears to be mis configured
Chain INPUT (policy DROP)
target prot opt source destination
ACCEPT all -- anywhere anywhere
this will accept ALL incoming connections
Frank Razenberg wrote:
Hi Ajitabh,
I attached the information you asked. Apologies for the mail I just sent
to your address instead of to the mailing list.
Frank
Ajitabh Pandey wrote:
Hi Frank,
2009/1/21 Frank Razenberg <[email protected]
<mailto:[email protected]>>
[snipped....]
Some details that might help identify my problem:
- I set ipmasq to start after services have been started using
dpkg-reconfigure
- in /etc/network/interfaces, for eth0 I execute a script after
eth0 is brought up. This script initializes iptables rules and ip
masquerading.
- I use dnsmasq as DHCP and DNS server.
- The eth0 interface gets it's IP from a DHCP server by my ISP,
eth1 has a static ip.
To start with, it will be helpful if you could send the following:
(1.) The iptables rule-set
(2.) Output of ifconfig
(3.) Output of route -n
(4.) Contents of /etc/hosts and /etc/resolv.conf
(5.) DNSMASQ configuration file.
Regards.
-- Ajitabh Pandey
http://www.ajitabhpandey.info/ | http://www.unixclinic.net/
ICQ - 150615062
Registered Linux User - 240748
--
Mark Chong
System Administrator
Quick Knowledge
p: 03 9804 2130
f: 1800 657 778
mail: [email protected]
web: www.qk.com.au
--
To UNSUBSCRIBE, email to [email protected]
with a subject of "unsubscribe". Trouble? Contact [email protected]
