On Wednesday 22 October 2003 8:32 pm, W. Paul Mills wrote: >-----BEGIN PGP SIGNED MESSAGE----- >Hash: SHA1 > >On Wednesday 22 October 2003 18:02, Jeff Elkins wrote: >> I'm compiling busybox-1.00-pre2/pre3 for the sharp rom and I get >> errors upon boot: >> >> /etc/mtab is read-only >> mount /dev/mmcda1 fails >> >> however, after boot completes, everything seems to work fine. >> Any ideas on what might be causing the initial errors? I'm >> wondering if there's a compile option I missed... >> >> Thanks, >> >> Jeff Elkins > >Sounds like you try to mount /dev/mmcda1 before it's module is >loaded. Then later it loads "as if" the card was just inserted. It >cannot load from /etc/fstab because the module is not loaded yet. >(I'm going from memory here, hope that's right.) >
Thanks for the reply Paul. I'm pretty sure this is a busybox problem, since the system boots w/o errors when using a Sharp-supplied busybox. However, I did just compile the last stable 60.5 release and it's running w/o errors, so I may stick with that and report the error to the busybox folks. Jeff -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
