Hi Dean, It would seem that the PDC ( Processor Dependant Code ) layer of your machine is not reading the lif image that I guess should be on that CD.
PA-RISC machines have a modular approach to just about everything and booting is no exception. When you switch the things on you get the PDC layer, This does all sorts of checks ( loads of them on faster machines ). This will then load the IPL ( Inital Program Loader ) this is also known as the ISL ( Inital System Loader ) As far as I know there is no differance between the two. You can interact with the IPL if you want to when loading HP-UX and I think MPE. It can be useful at times. The IPL layer then loads the secondary boot loader. This depends on your operating system. If you run HP-UX then it's called ( strangely enough ) hpux. This does the loading of the kernel. I'm guessing at this stage but it looks very much like PALO replaces the IPL layer and does the kernel loading itself. This is cheating from HP's point of view but nevermind, it does work. The PDC layer will think whatever PALO installed is an IPL and will have a go at loading it. I have seen that init=-7 message a few times whilst installing HP-UX. I think it means it can't find a lif image and is normaly followed by 6 or 7 lines of numbers. What I recommend is as follows. You can mount that CD on a linux box to check the filesystem is OK. Don't mount -o loop the iso image and assume they are the same, they might not be. If it is ok try a sea ipl at the pdc prompt on your HP machine. That will give you a list of everything with an IPL ( and all DHCP servers on your network, most likely none. ) If your CD isn't there then you don't have PALO / ISL or anything else that does that job and it can't be booted. Try burning it again. Or if you have a network try a network install. Have Fun, Stephen On Friday 12 Oct 2001 10:16 pm, Dean Allen Provins wrote: > Hello > > I came into possession of a 715/75, which I understood was supported. > I obtained the ISO CD image, and a friend burned it for me (raw, with > closure, he assured me). > > I popped it into the external drive and powered up. > > Powering up gave me three boot options (I pressed ESC to get these): > > P0 scsi.6.0 Seagate ST11200N > P1 scsi.3.0 Sony CDROM CDU-561 > P2 scsi.0.0 Teac FC-1 HF V7 > > The Sony drive was used as I suspected the supplied HP drive (I've > forgotten the model) failed, virtually in the same manner as the Sony > (as follows): > > b p1: > > Trying scsi.3.0 > Failed to initialize scsi.3.0 > ENTRY_INIT status = -7 > > ....dump of some registers... > > Going into admin mode let me do another search, which found ONLY the > P0 device. > > I attempted to compare the CD image with the ungzipped ISO image, but > of course I couldn't mount it. The message was "mount: No medium > found", which I presume resulted from not having a file system on the > CD. > > Can any reader tell me if I have a CD problem, or a hardware problem > (and what the solution might be)? > > Thanks, > > Dean
