On Tue, 22 Dec 1998 at 22:09:45 +0100, Marcus Brinkmann wrote: > On Tue, Dec 22, 1998 at 03:16:18PM -0500, John Tobey wrote: > > Found them. Installed them. Booted them--at least as far as "Hurd > > server bootstrap: ext2fs.static exec_" where it hangs. Any > > suggestions? > > > > For a rough idea of the steps I took, see > > > > http://people.ne.mediaone.net/jtobey/inst.html > > Hmmm. Looked fine. As long as I didn't screw up my upload > (I admit that I didn't test it much, as the prior build did work). > Mmmh. I really should have done some testing, because I used Gord's > new specs file instead of my own. > On the other hand, if it comes as far the static bins should be fine > (as serverboot is also one). > > Try installing also libc6-dev!
I did install libc6-dev. (btw, there doesn't look to be any reason not to use deb_install for libc6-dev. Is there any?) > Try without a swap device. > > Do you have the ld.so.1 link? (or is it ld.so?) Yep, yep. > Sorry for being so lame. My whole system went fubar and I am currently > recovering my partition table... at least I hope so. Aw, come on, you're doing a great job! Did I mention that my hurd partition straddles the 500MB line and I have one of those old controllers? Once when I untarred a hurd onto it, it couldn't boot because boot/gnumach was (I guess) beyond 500MB. Now I'm kind of assuming that I wouldn't get this far if that were a concern this time. (I have gotten as far as sh and emacs with an earlier hurd.) > Let me know if something changes. For your amusement, I include here the terminal output: AT386 boot: physical memory from 0x0 to 0x1800000 pci_init: no BIOS32 detected hda: Conner Peripherals 1620MB - CFS1621A, 1548MB w/0kB Cache, CHS=3146/16/63 hda: IRQ probe failed (0) hdb: IRQ probe failed (0) hdb: IRQ probe failed (0) hdb: CD-ROM CDU55E, ATAPI CDROM drive hdb: IRQ probe failed (0) ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 Floppy drive(s): fd0 is 1.44M FDC 0 is an 8272A scsi : 0 hosts. scsi : detected total. eth0: D-Link DE-600 pocket adapter: not at I/O 0x378 D-Link DE-620 pocket adatper not identified in the printer port eth1: D-Link DE-600 pocket adapter: not at I/O 0x378 D-Link DE-620 pocket adatper not identified in the printer port Partition check: hda: hda1 hda2 hda3 < hda5 hda6 hda7 > com0: at atbus0, port = 3f8, spl = 6, pic = 4. (DOS COM1) com1: at atbus1, port = 2f8, spl = 6, pic = 3. (DOS COM2) hda3: bad access: block=28, count=2 end_request: I/O error, dev 03:03, sector 28 (serverboot): Running without any paging Hurd server bootstrap: ext2fs.static exec_ (blinking cursor after exec)
