Hi,
> settrans -fg /servers/socket/2 /hurd/pfinet --interfaces=eth0 You mean interface of course (ie without the `s'). > --address=192.168.1.3 --gateway=192.168.1.1 --netmask=255.255.255.0 > > When i run this command it takes me directly back to the command prompt, > no message to say if it did or didnt do anything, when i do a ps aux > there is mention of /hurd/pflocal, but no mention of /hurd pfinet, > should there be ? Try settrans -fgap ... This will force it to startup immediately so that you can see errors. > I get the occasional lockup as well, often when using dselect, is this > normal ? Are you using swap? This is _very_ important. > Is debconf 0.3.53 supposed to work? it wont install on my system, fails > --configure. It worked on mine once I got several of the packages from alpha.gnu.org. > On the bright side i had a go at compiling busybox (used by > boot-floppies, busybox.lineo.com) i think most of them will work without > much effort at all. Thanks, sounds good. Best regards, -Neal -- Neal H Walfield University of Massachusetts at Lowell [EMAIL PROTECTED] or [EMAIL PROTECTED]
