I'm using a system with an Adaptec 3940 (dual channel pci scsi card), so I would guess the problem is not the SCSI card.
On Sun, 12 Aug 2001 13:09:12 +0200, Joachim Nilsson wrote: >On Sun, Aug 12, 2001 at 06:58:09PM +1000, Dave McDonald wrote: >> The floppies seem to install fine and the Grub boot floppy loads the >> images from the /boot directory on the hard disk, but the boot stops >> (without any error messages) after noting that 419 microcode >> instructions have been loaded into the the Adaptec 2940U card. >> [snip] >> Drives: >> CDROM: Hitachi CDR130 /dev/hdc (Linux) >> HDD: Seagate ST3151N (ID#0) >> Partition 1: 128 Mb, type 82 (swap) >> Partition 2: remainder of 2 Gb drive > ~~~~~~~~~~~~~~~~~ >I'm unsure, but to my knowledge Hurd/GNUmach doesn't yet understand >partitions greater than 1024 MB. Try using two smaller partitions >(<1024 MB). > >If that doesn't help maybe your Adaptec SCSI-card isn't yet ported. >Some of the developers might be aware of this ... > > > /Joachim > >-- >Joachim Nilsson <[EMAIL PROTECTED]> >+46-(0)21-123348 <http://www.vmlinux.org/crash/> > > >-- >To UNSUBSCRIBE, email to [EMAIL PROTECTED] >with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] >
