On Thu, 2003-04-03 at 08:36, Ian Wienand wrote: > Hello, > > Does anyone know if there is some trick to getting linux console > output through the management processor on the rx2600? all the > documentation states that the management card processor output mirrors > the system console when not it it's managment mode -- which it does > until linux starts.
Which version of firmware do you have installed? When I upgraded the System and BMC firmware to 1.05 (System = 1.82, BMC = 1.40) I suddenly got the same behavior. Before the upgrade I had ttyS0 through the management processor, afterwards, however, I have the following mapping: console/serial A: ttyS0 serial B: ttyS1 console/MP: ttyS3 (same as through the mangagement lan) remote/MP: ----- ups/MP: ttyS2 I would like to get the old behaviour back too. /torkel
