Hi All:
I have seen references to problems like these on the list but with no clear resolution.
I have a newly acquired ZX6000 system with version 2.21 ROM. I have been trying to install lenny on this system with no success and I wonder if there are tricks I am just not aware of.
I have no problem getting to boot installation menu with three kernel options: Install, Install (Expert mode), and Rescue. Whenever I select any one of these, I get the kernel loading line and then the line telling me it is loading intrd.gz and when this latter says "done" everything stops.
This happened when I was using the VGA output and when I tried connecting to the console as well. As a side note, once I started working on the console, I can't get the system to go back to the VGA display again.
I tried making sure that the console was set to 9600 baud since that is the speed of the serial port I have connected it to but this does not change anything.
I tried the current squeeze image since there was a note in August 2008 saying that the kernel in lenny might be the problem.
I would appreciate any help the list can give me, I haven't found anything in the installation manual which addresses this problem.
Please cc me as I am not subscribed to this list. Thanks, Carlo -- Carlo U. Segre -- Professor of Physics Associate Dean for Graduate Admissions, Graduate College Illinois Institute of Technology Voice: 312.567.3498 Fax: 312.567.3494 [email protected] http://www.iit.edu/~segre [email protected] -- To UNSUBSCRIBE, email to [email protected] with a subject of "unsubscribe". Trouble? Contact [email protected]
