Hi all! I have used ipv6 thru 6to4 tunnel occasionally few times a month. However, now I noticed that my tunnel doesn't work anymore. I have used following commands to set it up on boot:
ip tunnel add tun6to4 mode sit remote any local 193.166.92.78 ip link set dev tun6to4 up ip -6 addr add 2002:c1a6:5c4e:1::1/64 dev tun6to4 ip -6 route add 2000::/3 via ::192.88.99.1 dev tun6to4 metric 1 Now after last command I get error message: RTNETLINK answers: No route to host Are my commands right? is my prefix correct? Is this related to kernel configuration? When it was working I used 2.4.17 or 2.4.19pre8. Now I'm using 2.4.19. Here are my network options in kernel: # # Networking options # CONFIG_PACKET=y CONFIG_PACKET_MMAP=y CONFIG_NETLINK_DEV=y CONFIG_NETFILTER=y # CONFIG_NETFILTER_DEBUG is not set CONFIG_FILTER=y CONFIG_UNIX=y CONFIG_INET=y CONFIG_IP_MULTICAST=y # CONFIG_IP_ADVANCED_ROUTER is not set # CONFIG_IP_PNP is not set # CONFIG_NET_IPIP is not set # CONFIG_NET_IPGRE is not set # CONFIG_IP_MROUTE is not set # CONFIG_ARPD is not set # CONFIG_INET_ECN is not set CONFIG_SYN_COOKIES=y CONFIG_IPV6=y Thank you :) ~ *** *** *** *** *** *** *** *** *** *** *** * Ismo Laitinen | "Thinking computer... * *Tampere University of Technology| ...you mean like * * [EMAIL PROTECTED] | a swimming ship" * * gromit.ton.tut.fi/~laitinei/ | * *** *** *** *** *** *** *** *** *** *** ***
