Dear All,
I have configured my router to advertise its ipv6 prefix and the nd packets are received for the debian host updated with the testing packages. Just after the boot the interface "Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet" is getting a global ipv6 address correctly but after a while the address is lost and on the interface only the link local address remains. linux:~# dmesg | grep eth0 [ 1.894066] eth0: Tigon3 [partno(BCM95704A6) rev 2002] (PCIX:133MHz:64-bit) MAC address 00:0b:db:95:18:cc [ 1.894074] eth0: attached PHY is 5704 (10/100/1000Base-T Ethernet) (WireSpeed[1]) [ 1.894079] eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] TSOcap[1] [ 1.894083] eth0: dma_rwctrl[769f4000] dma_mask[64-bit] [ 27.186395] ADDRCONF(NETDEV_UP): eth0: link is not ready [ 28.737619] tg3: eth0: Link is up at 100 Mbps, full duplex. [ 28.737624] tg3: eth0: Flow control is on for TX and on for RX. [ 28.737828] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready Why is that happening? What can I do about that? I cannot locate any logs regarding the ipv6 procedures. Any ideas? George Manousakis
