Your message dated Wed, 18 Dec 2024 18:29:31 +0100
with message-id
<w5bhissdythrmuba5ij4rk7hxenxphk2jglgsfaozxirkcaj62@iawvq7prhdx7>
and subject line Re: Bug#1089323: Andrew_J.Chapman
has caused the Debian Bug report #1089323,
regarding linux-image-6.1.0-28-arm64: systemd can login, sysvinit hangs fatal
before login
to be marked as done.
This means that you claim that the problem has been dealt with.
If this is not the case it is now your responsibility to reopen the
Bug report if necessary, and/or fix the problem forthwith.
(NB: If you are a system administrator and have no idea what this
message is talking about, this may indicate a serious mail system
misconfiguration somewhere. Please contact [email protected]
immediately.)
--
1089323: https://bugs.debian.org/cgi-bin/bugreport.cgi?bug=1089323
Debian Bug Tracking System
Contact [email protected] with problems
--- Begin Message ---
Package: src:linux
Version: 6.1.119-1
Severity: important
X-Debbugs-Cc: [email protected]
Dear Maintainer,
2 red lines from journalctl
meson_uart c11084c0.serial: Failed to create device link (0x180) with wifi32k
lima d00c0000.gpu: error -ENODEV: _opp_set_regulators: no regulator (mali) found
Note: firmware meson installed
PC Khadas VIM1 arm64 Open Source TV Box 2014? buggy?
All the best, to your health
*** Reporter, please consider answering these questions, where appropriate ***
* What led up to the situation?
* What exactly did you do (or not do) that was effective (or
ineffective)?
* What was the outcome of this action?
* What outcome did you expect instead?
*** End of the template - remove these template lines ***
-- Package-specific info:
** Version:
Linux version 6.1.0-28-arm64 ([email protected]) (gcc-12 (Debian
12.2.0-14) 12.2.0, GNU ld (GNU Binutils for Debian) 2.40) #1 SMP Debian
6.1.119-1 (2024-11-22)
** Command line:
BOOT_IMAGE=/boot/vmlinuz-6.1.0-28-arm64
root=UUID=dceb7e61-2701-49d9-90a7-e6d5f877f096 ro quiet
init=/lib/systemd/systemd
** Tainted: C (1024)
* staging driver was loaded
** Kernel log:
Unable to read kernel log; any relevant messages should be attached
** Model information
Device Tree model: Khadas VIM
** Loaded modules:
cpufreq_ondemand
cpufreq_conservative
cpufreq_powersave
cpufreq_userspace
nls_ascii
nls_cp437
vfat
fat
ath9k_htc
ath9k_common
ath9k_hw
snd_soc_hdmi_codec
snd_soc_core
ath
hci_uart
btqca
snd_pcm_dmaengine
mac80211
btrtl
snd_pcm
btbcm
btintel
snd_timer
bluetooth
snd
soundcore
brcmfmac
brcmutil
dw_hdmi_i2s_audio
libarc4
cfg80211
meson_vdec(C)
scpi_cpufreq
jitterentropy_rng
clk_scpi
sha512_generic
videobuf2_dma_contig
scpi_hwmon
meson_dw_hdmi
v4l2_mem2mem
sha512_arm64
videobuf2_memops
dw_hdmi
videobuf2_v4l2
meson_drm
polyval_ce
polyval_generic
ghash_ce
aes_neon_bs
videobuf2_common
gf128mul
drm_display_helper
ir_nec_decoder
sha2_ce
aes_neon_blk
lima
display_connector
drm_dma_helper
videodev
rc_khadas
governor_simpleondemand
sha256_arm64
aes_ce_blk
drm_kms_helper
drbg
ao_cec
sha1_ce
aes_ce_cipher
gpu_sched
drm_shmem_helper
ansi_cprng
cec
mc
amlogic_gxl_crypto
meson_ir
sg
ecdh_generic
rfkill
drm
ecc
rc_core
platform_mhu
joydev
crypto_engine
pwm_meson
nvmem_meson_efuse
meson_rng
meson_canvas
meson_saradc
leds_pwm
meson_gxbb_wdt
evdev
dm_mod
dax
efi_pstore
fuse
loop
configfs
efivarfs
ip_tables
x_tables
autofs4
ext4
crc16
mbcache
jbd2
crc32c_generic
sd_mod
t10_pi
crc64_rocksoft
crc64
crc_t10dif
crct10dif_generic
hid_generic
usbhid
hid
uas
usb_storage
scsi_mod
scsi_common
xhci_plat_hcd
xhci_hcd
dwc2
dwc3
udc_core
meson_gxl
usbcore
dwmac_generic
ulpi
dwmac_meson8b
stmmac_platform
stmmac
pcs_xpcs
phylink
mdio_mux_mmioreg
mdio_mux
of_mdio
fixed_phy
fwnode_mdio
crct10dif_ce
clk_pwm
crct10dif_common
dwc3_meson_g12a
libphy
meson_gx_mmc
roles
usb_common
i2c_meson
arm_scpi
adc_keys
fixed
industrialio
gpio_keys_polled
** Network interface configuration:
*** /etc/network/interfaces:
auto lo
iface lo inet loopback
iface wlan1 inet dhcp
iface end0 inet dhcp
wpa-ssid BT-FRAHWW
wpa-psk **************
** Network status:
*** IP interfaces and addresses:
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group
default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
inet6 ::1/128 scope host noprefixroute
valid_lft forever preferred_lft forever
2: end0: <NO-CARRIER,BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state
DORMANT group default qlen 1000
link/ether 16:5e:c6:57:5a:3d brd ff:ff:ff:ff:ff:ff
inet 192.168.100.2/24 brd 192.168.100.255 scope global dynamic end0
valid_lft 84950sec preferred_lft 84950sec
3: wlan0: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN group default
qlen 1000
link/ether 08:e9:f6:31:b1:26 brd ff:ff:ff:ff:ff:ff
4: wlx00127b217e6e: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN group
default qlen 1000
link/ether 00:12:7b:21:7e:6e brd ff:ff:ff:ff:ff:ff
*** Device statistics:
Inter-| Receive | Transmit
face |bytes packets errs drop fifo frame compressed multicast|bytes
packets errs drop fifo colls carrier compressed
lo: 0 0 0 0 0 0 0 0 0
0 0 0 0 0 0 0
end0: 11222503 7742 0 0 0 0 0 0 226442
2215 0 0 0 0 0 0
wlan0: 0 0 0 0 0 0 0 0 0
0 0 0 0 0 0 0
wlx00127b217e6e: 0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0
*** Protocol statistics:
Ip:
Forwarding: 2
4615 total packets received
0 forwarded
0 incoming packets discarded
4615 incoming packets delivered
2187 requests sent out
Icmp:
0 ICMP messages received
0 input ICMP message failed
ICMP input histogram:
0 ICMP messages sent
0 ICMP messages failed
ICMP output histogram:
Tcp:
16 active connection openings
0 passive connection openings
0 failed connection attempts
0 connection resets received
0 connections established
4568 segments received
2162 segments sent out
0 segments retransmitted
0 bad segments received
26 resets sent
Udp:
47 packets received
0 packets to unknown port received
0 packet receive errors
45 packets sent
0 receive buffer errors
0 send buffer errors
UdpLite:
TcpExt:
1 TCP sockets finished time wait in fast timer
5 delayed acks sent
Quick ack mode was activated 4 times
744 packet headers predicted
47 acknowledgments not containing data payload received
20 predicted acknowledgments
TCPBacklogCoalesce: 3
TCPDSACKOldSent: 4
13 connections reset due to unexpected data
TCPRcvCoalesce: 2336
TCPOFOQueue: 134
TCPAutoCorking: 6
TCPOrigDataSent: 131
TCPDelivered: 133
TCPAckCompressed: 83
IpExt:
InBcastPkts: 2
InOctets: 10951525
OutOctets: 193565
InBcastOctets: 1152
InNoECTPkts: 7735
MPTcpExt:
** PCI devices:
** USB devices:
Bus 001 Device 006: ID 03f0:354a HP, Inc Slim Keyboard
Bus 001 Device 005: ID 0bda:0119 Realtek Semiconductor Corp. Storage Device (SD
card reader)
Bus 001 Device 004: ID 1a40:0101 Terminus Technology Inc. Hub
Bus 001 Device 003: ID 040d:3801 VIA Technologies, Inc. VIA USB2.0 WLAN
Bus 001 Device 002: ID 1a40:0801 Terminus Technology Inc. USB 2.0 Hub
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
-- System Information:
Debian Release: 12.8
APT prefers stable-updates
APT policy: (500, 'stable-updates'), (500, 'stable-security'), (500, 'stable')
Architecture: arm64 (aarch64)
Kernel: Linux 6.1.0-28-arm64 (SMP w/4 CPU threads)
Kernel taint flags: TAINT_CRAP
Locale: LANG=en_GB.UTF-8, LC_CTYPE=en_GB.UTF-8 (charmap=UTF-8),
LANGUAGE=en_GB:en
Shell: /bin/sh linked to /usr/bin/dash
Init: systemd (via /run/systemd/system)
LSM: AppArmor: enabled
Versions of packages linux-image-6.1.0-28-arm64 depends on:
ii initramfs-tools [linux-initramfs-tool] 0.142+deb12u1
ii kmod 30+20221128-1
ii linux-base 4.9
Versions of packages linux-image-6.1.0-28-arm64 recommends:
ii apparmor 3.0.8-3
pn firmware-linux-free <none>
Versions of packages linux-image-6.1.0-28-arm64 suggests:
pn debian-kernel-handbook <none>
pn linux-doc-6.1 <none>
Versions of packages linux-image-6.1.0-28-arm64 is related to:
pn firmware-amd-graphics <none>
pn firmware-atheros <none>
pn firmware-bnx2 <none>
pn firmware-bnx2x <none>
pn firmware-brcm80211 <none>
pn firmware-cavium <none>
pn firmware-intel-sound <none>
pn firmware-intelwimax <none>
pn firmware-ipw2x00 <none>
pn firmware-ivtv <none>
pn firmware-iwlwifi <none>
pn firmware-libertas <none>
pn firmware-linux-nonfree <none>
pn firmware-misc-nonfree <none>
pn firmware-myricom <none>
pn firmware-netxen <none>
pn firmware-qlogic <none>
pn firmware-realtek <none>
pn firmware-samsung <none>
pn firmware-siano <none>
pn firmware-ti-connectivity <none>
pn xen-hypervisor <none>
-- no debconf information
--- End Message ---
--- Begin Message ---
On Thu, Dec 12, 2024 at 10:08:31AM +0000, Andrew Chapman wrote:
> Please close this bug, my mistake, needed kernel cmdline console=ttyAML0
> console=tty0, inittab, T0:23:respawn:/sbin/getty -L ttyAML0 vt100
Closed issue. Thanks for your feedback.
Best regards
Uwe
signature.asc
Description: PGP signature
--- End Message ---
