FUJITA Tomonori wrote, on 22/12/08 12:39:
Sorry about the problem. Can you try this patch?
diff --git a/drivers/scsi/eata.c b/drivers/scsi/eata.c
index a73a6bb..976cdd5 100644
--- a/drivers/scsi/eata.c
+++ b/drivers/scsi/eata.c
@@ -1626,8 +1626,15 @@ static void map_dma(unsigned int i, struct hostdata *ha)
cpp->sense_len = SCSI_SENSE_BUFFERSIZE;
- count = scsi_dma_map(SCpnt);
- BUG_ON(count < 0);
+ if (!scsi_sg_count(SCpnt)) {
+ cpp->data_len = 0;
+ return;
+ }
+
+ count = pci_map_sg(ha->pdev, scsi_sglist(SCpnt), scsi_sg_count(SCpnt),
+ pci_dir);
+ BUG_ON(!count);
+
scsi_for_each_sg(SCpnt, sg, count, k) {
cpp->sglist[k].address = H2DEV(sg_dma_address(sg));
cpp->sglist[k].num_bytes = H2DEV(sg_dma_len(sg));
@@ -1655,7 +1662,9 @@ static void unmap_dma(unsigned int i, struct hostdata *ha)
pci_unmap_single(ha->pdev, DEV2H(cpp->sense_addr),
DEV2H(cpp->sense_len), PCI_DMA_FROMDEVICE);
- scsi_dma_unmap(SCpnt);
+ if (scsi_sg_count(SCpnt))
+ pci_unmap_sg(ha->pdev, scsi_sglist(SCpnt), scsi_sg_count(SCpnt),
+ pci_dir);
if (!DEV2H(cpp->data_len))
pci_dir = PCI_DMA_BIDIRECTIONAL;
Thanks, I applied the patch manually against the Debian 2.6.27 kernel
source at http://kernel-archive.buildserver.net/ and after starting the
patched kernel, the eata module loaded successfully. I mounted the
filesystems on the attached scsi disk and ran ls -alR on all filesystems
successfully.
dmesg reported:
[ 168.343910] PCI: setting IRQ 5 as level-triggered
[ 168.343944] pci 0000:00:0a.0: found PCI INT A -> IRQ 5
[ 168.346548] EATA/DMA 2.0x: Copyright (C) 1994-2003 Dario Ballabio.
[ 168.346657] EATA config options -> tm:1, lc:y, mq:16, rs:y, et:n,
ip:y, ep:n, pp:y.
[ 168.346769] EATA0: 2.0C, PCI 0xe010, IRQ 5, BMST, SG 122, MB 64.
[ 168.346863] EATA0: wide SCSI support enabled, max_id 16, max_lun 8.
[ 168.346958] EATA0: SCSI channel 0 enabled, host target ID 7.
[ 168.411912] scsi0 : EATA/DMA 2.0x rev. 8.10.00
[ 169.953101] scsi 0:0:6:0: Direct-Access IBM DCAS-34330W
S65A PQ: 0 ANSI: 2
[ 169.953239] scsi 0:0:6:0: cmds/lun 16, sorted, simple tags.
[ 172.189180] Driver 'sd' needs updating - please use bus_type methods
[ 172.193186] sd 0:0:6:0: [sda] 8466688 512-byte hardware sectors (4335 MB)
[ 172.230078] sd 0:0:6:0: [sda] Write Protect is off
[ 172.230191] sd 0:0:6:0: [sda] Mode Sense: b3 00 00 08
[ 172.251052] sd 0:0:6:0: [sda] Write cache: enabled, read cache:
enabled, doesn't support DPO or FUA
[ 172.254288] sd 0:0:6:0: [sda] 8466688 512-byte hardware sectors (4335 MB)
[ 172.263454] sd 0:0:6:0: [sda] Write Protect is off
[ 172.263551] sd 0:0:6:0: [sda] Mode Sense: b3 00 00 08
[ 172.284232] sd 0:0:6:0: [sda] Write cache: enabled, read cache:
enabled, doesn't support DPO or FUA
[ 172.284375] sda: sda1 sda2 < sda5 >
[ 172.322394] sd 0:0:6:0: [sda] Attached SCSI disk
As with 2.6.22 kernels gnu fdisk had problems with the scsi drive, but
cfdisk and sfdisk were ok:
[ 222.575704] fdisk[1996]: segfault at 60 ip 41b6d443 sp bff98034 error
4 in libc-2.7.so[41af7000+155000]
[ 249.063672] lfdisk[1998]: segfault at 60 ip 41b6d443 sp bfe50084
error 4 in libc-2.7.so[41af7000+155000]
The gfdisk/lfdisk error was reported as Debian Bug#463720:
Thanks very much for the rapid response to this bug report!
Arthur.
--
To UNSUBSCRIBE, email to debian-kernel-requ...@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org
