Your message dated Sat, 8 Jun 2013 12:16:55 +0200 with message-id <[email protected]> and subject line Closing has caused the Debian Bug report #595223, regarding linux-image-2.6-xen-amd64: channel scanning with b2c2-flexcop-pci to be marked as done.
This means that you claim that the problem has been dealt with. If this is not the case it is now your responsibility to reopen the Bug report if necessary, and/or fix the problem forthwith. (NB: If you are a system administrator and have no idea what this message is talking about, this may indicate a serious mail system misconfiguration somewhere. Please contact [email protected] immediately.) -- 595223: http://bugs.debian.org/cgi-bin/bugreport.cgi?bug=595223 Debian Bug Tracking System Contact [email protected] with problems
--- Begin Message ---Package: linux-image-2.6-xen-amd64 Version: 2.6.32+28 Severity: normal Hi, with debian squeeze kernel my Sky2PC/SkyStar 2 DVB-S rev 2.6 is not able to scan for channels. It's the same in arch i386 and amd64. When i use the stable Lenny kernel everything is ok. The modules are loaded sucessfully, but i'm not able to scan for channels. Attached you can find the output of dmesg, lspci-vv and scan. dmesg: [ 1.458718] udev: starting version 160 [ 1.914121] input: PC Speaker as /devices/platform/pcspkr/input/input1 [ 1.994384] Error: Driver 'pcspkr' is already registered, aborting... [ 2.107652] b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip loaded successfully [ 2.117598] flexcop-pci: will use the HW PID filter. [ 2.117653] flexcop-pci: card revision 2 [ 2.117682] b2c2_flexcop_pci 0000:00:00.0: enabling device (0000 -> 0003) [ 2.117777] b2c2_flexcop_pci 0000:00:00.0: Xen PCI enabling IRQ: 21 [ 2.117791] alloc irq_desc for 21 on node 0 [ 2.117794] alloc kstat_irqs on node 0 [ 2.132209] DVB: registering new adapter (FlexCop Digital TV device) [ 2.134257] b2c2-flexcop: MAC address = 00:d0:d7:12:34:b0 [ 2.134848] CX24123: cx24123_i2c_readreg: reg=0x0 (error=-121) [ 2.134855] CX24123: wrong demod revision: 87 [ 2.369535] b2c2-flexcop: found 'ST STV0299 DVB-S' . [ 2.369549] DVB: registering adapter 0 frontend 0 (ST STV0299 DVB-S)... [ 2.369620] b2c2-flexcop: initialization of 'Sky2PC/SkyStar 2 DVB-S rev 2.6' at the 'PCI' bus controlled by a 'FlexCopIIb' complete [ 2.492035] Adding 2097144k swap on /dev/xvda1. Priority:-xtents:1 across:2097144k SS [ 2.619564] EXT3 FS on xvda2, internal journal lspci-vv: lspci -vv 00:00.0 Network controller: Techsan Electronics Co Ltd B2C2 FlexCopII DVB chip / Technisat SkyStar2 DVB card (rev 02) Subsystem: Techsan Electronics Co Ltd B2C2 FlexCopII DVB chip / Technisat SkyStar2 DVB card Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Latency: 64 Interrupt: pin A routed to IRQ 21 Region 0: Memory at feaf0000 (32-bit, non-prefetchable) [size=64K] Region 1: I/O ports at bc00 [size=32] Kernel driver in use: b2c2_flexcop_pci scan: scan /usr/share/dvb/dvb-s/Astra-19.2E > /tmp/channels.conf scanning /usr/share/dvb/dvb-s/Astra-19.2E/dvb-s/Astra-19.2E > /tmp/channels.conf using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0' initial transponder 12551500 V 22000000 5 >>> tune to: 12551:v:0:22000 DVB-S IF freq is 1951500 WARNING: filter timeout pid 0x0011 WARNING: filter timeout pid 0x0000 WARNING: filter timeout pid 0x0010 dumping lists (0 services) Done. Thanks in advance, regards Herbert -- System Information: Debian Release: squeeze/sid APT prefers testing APT policy: (500, 'testing') Architecture: amd64 (x86_64) Kernel: Linux 2.6.32-5-xen-amd64 (SMP w/1 CPU core) Locale: LANG=C, LC_CTYPE=C (charmap=ANSI_X3.4-1968) Shell: /bin/sh linked to /bin/dash Versions of packages linux-image-2.6-xen-amd64 depends on: ii linux-image-2.6.32-5-xen-amd6 2.6.32-20 Linux 2.6.32 for 64-bit PCs, Xen d linux-image-2.6-xen-amd64 recommends no packages. linux-image-2.6-xen-amd64 suggests no packages. -- no debconf information
--- End Message ---
--- Begin Message ---Hi, your bug has been filed against the "linux-2.6" source package and was filed for a kernel older than the recently released Debian 7.0 / Wheezy with a severity less than important. We don't have the ressources to reproduce the complete backlog of all older kernel bugs, so we're closing this bug for now. If you can reproduce the bug with Debian Wheezy or a more recent kernel from testing or unstable, please reopen the bug by sending a mail to [email protected] with the following three commands included in the mail: reopen BUGNUMBER reassign BUGNUMBER src:linux thanks Cheers, Moritz
--- End Message ---
