Hi,

I've got the same problem with my Asus laptop.  It is a winmodem, integrated 
on the sound chip.  There are no linux drivers for this winmodem AFAIK.  Too 
bad as I would like to have a driver for it as much as you would.

Buon Natale.

Ren�.

Ralf Gerlich wrote:

> Hi all!
> 
> I'm searching for a way to get my ESS ES1989 Modem to work with Linux 
> 2.4. I've heard there were binary drivers by ESS Tech. for 2.2, but (as 
> if I didn't expect this) they don't seem to work with 2.4.
> 
> I attached the output lspci -vv produces for the Modem and Audio Card.
> 
> Thanx for any support,
> 
> Ralf
> 
> 
> 
> ------------------------------------------------------------------------
> 
> 00:06.0 Multimedia audio controller: ESS Technology ES1988 Allegro-1 (rev 12)
>       Subsystem: Asustek Computer, Inc.: Unknown device 1049
>       Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- 
>SERR- FastB2B-
>       Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- 
><MAbort- >SERR- <PERR-
>       Latency: 32 (500ns min, 6000ns max)
>       Interrupt: pin A routed to IRQ 10
>       Region 0: I/O ports at f800 [size=256]
>       Capabilities: [c0] Power Management version 2
>               Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA 
>PME(D0-,D1+,D2+,D3hot+,D3cold-)
>               Status: D0 PME-Enable- DSel=0 DScale=0 PME-
> 
> 00:06.1 Communication controller: ESS Technology ESS Modem (rev 12)
>       Subsystem: Asustek Computer, Inc.: Unknown device 1049
>       Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- 
>SERR- FastB2B-
>       Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- 
><MAbort- >SERR- <PERR-
>       Interrupt: pin A routed to IRQ 10
>       Region 0: I/O ports at f400 [disabled] [size=256]
>       Capabilities: [c0] Power Management version 2
>               Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=100mA 
>PME(D0-,D1+,D2+,D3hot+,D3cold+)
>               Status: D0 PME-Enable- DSel=0 DScale=0 PME+
> 
> 


-- 
Ren� Seindal ([EMAIL PROTECTED])              http://www.seindal.dk/rene/
 


--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]

Reply via email to