Hi Colin, Set the ssid to "default" as your scan proposes...
greeting Felix On Fri, 2005-06-17 at 08:06 +0100, Colin Cotter wrote: > Dear List, > > I am trying to get my Centrino wireless card working on my > Fujitsu-Siemans Lifebook S7010 running Debian with the 2.6.8 kernel. > > I have successfully installed the ipw2200 drivers and the device comes > up as eth1. However when I select the "networking" GUI program, eth1 > is set as "unavailable". > > Please could you help me find what is wrong? Relevant information at > the bottom of this email. > > all the best > > --Colin > > [relevant iwconfig output] > eth1 unassociated ESSID:"Wireless1" > Mode:Managed Channel=0 Access Point: 00:00:00:00:00:00 > Bit Rate=0 kb/s Tx-Power=20 dBm > RTS thr:off Fragment thr:off > Encryption key:off > Power Management:off > Link Quality:0 Signal level:0 Noise level:0 > Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 > Tx excessive retries:0 Invalid misc:4 Missed beacon:0 > > [relevant iwlist info] > > eth1 Scan completed : > Cell 01 - Address: 00:0E:2E:54:5D:F3 > ESSID:"default" > Protocol:IEEE 802.11bg > Mode:Master > Channel:11 > Encryption key:off > Bit Rate:54 Mb/s > Extra: Rates (Mb/s): 1 2 5.5 9 11 6 12 18 24 36 48 54 > Quality=91/100 Signal level=-37 dBm > Extra: Last beacon: 15ms ago > > [relevant ifconfig info] > eth1 Link encap:Ethernet HWaddr 00:12:F0:2E:4C:14 > inet6 addr: fe80::212:f0ff:fe2e:4c14/64 Scope:Link > UP BROADCAST MULTICAST MTU:1500 Metric:1 > RX packets:2885 errors:0 dropped:4 overruns:0 frame:0 > TX packets:1496 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) > Interrupt:11 Base address:0x6000 Memory:d0214000-d0214fff > -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
