Hi,
I've got the same problem with my Asus laptop. It is a winmodem, integrated
on the sound chip. There are no linux drivers for this winmodem AFAIK. Too
bad as I would like to have a driver for it as much as you would.
Buon Natale.
René.
Ralf Gerlich wrote:
Hi all!
I'm searching for a way to get my ESS ES1989 Modem to work with Linux
2.4. I've heard there were binary drivers by ESS Tech. for 2.2, but (as
if I didn't expect this) they don't seem to work with 2.4.
I attached the output lspci -vv produces for the Modem and Audio Card.
Thanx for any support,
Ralf
------------------------------------------------------------------------
00:06.0 Multimedia audio controller: ESS Technology ES1988 Allegro-1 (rev 12)
Subsystem: Asustek Computer, Inc.: Unknown device 1049
Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 32 (500ns min, 6000ns max)
Interrupt: pin A routed to IRQ 10
Region 0: I/O ports at f800 [size=256]
Capabilities: [c0] Power Management version 2
Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA
PME(D0-,D1+,D2+,D3hot+,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
00:06.1 Communication controller: ESS Technology ESS Modem (rev 12)
Subsystem: Asustek Computer, Inc.: Unknown device 1049
Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 10
Region 0: I/O ports at f400 [disabled] [size=256]
Capabilities: [c0] Power Management version 2
Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=100mA
PME(D0-,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME+
--
René Seindal ([EMAIL PROTECTED]) http://www.seindal.dk/rene/
