Hi all, I hava a dell Inspiron 6000 and I installed Etch on it. I must say that the installation was quite painless and the new kernel detected almost everything without tweaking e.g. the ipw2200 wireless card, touchpad, graphics card, sound chip. On the first go, I had a nice workig system.
Still I have following problems in my system. 1. Interesting thing is, I also have out of the box 3d acceleration with ati driver (automatically loaded kernel module). I could confirm this by running glxinfo which says "direct rendering: yes". But I cannot check the fps rate. When I run glxgears, I see the gears rotating, but it doesnt print any fps rate. In my slackware system at work, the command prints the fps rate. Do I need to tweak the xorg.conf for that ? What should I add ? 2. I still have a very low resolution, although the graphics card is detected propely. I can go upto 1680 x 1250 resolution, but I can only get 1024 x 768. I have ati mobility x300 graphic card with 128mb memory. Any suggestions ? regards, Hardik -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
