Hi all- More newbie questions:
I've got a stable Woody distro on my Pismo laptop and an internal VST 250 meg Zip drive in the CD Rom bay. I can mount an HFS formatted Zip like this: mount -t hfs /dev/hde ./zip ...and I can of course mount and read ISO9660 CDs when the CD in is the bay. I have the msdos driver loading, I think, although the output of dmesg attached below isn't too encouraging. (if anyone actually reads the dump, the msdos driver is called between the usb audio driver the appletalk driver...) Any pointers? Best, Charles Turner ==================================== Memory BAT mapping: BAT2=256Mb, BAT3=64Mb, residual: 0Mb Total memory = 320MB; using 2048kB for hash table (at c0400000) Linux version 2.4.18-newpmac ([EMAIL PROTECTED]) (gcc version 2.95.4 20011002 (Debian prerelease)) #1 Thu Mar 14 22:44:49 EST 2002 Found Uninorth memory controller & host bridge, revision: 8 Found a Keylargo mac-io controller, rev: 3, mapped at 0xfdf7f000 Processor NAP mode on idle enabled. PowerMac motherboard: PowerBook Pismo Found UniNorth PCI host bridge at 0xf0000000. Firmware bus number: 0->0 Found UniNorth PCI host bridge at 0xf2000000. Firmware bus number: 0->1 Found UniNorth PCI host bridge at 0xf4000000. Firmware bus number: 0->0 PMU driver 2 initialized for Core99, firmware: 0c On node 0 totalpages: 81920 zone(0): 81920 pages. zone(1): 0 pages. zone(2): 0 pages. Kernel command line: root=/dev/hda11 ro PowerMac using OpenPIC irq controller OpenPIC Version 1.2 (4 CPUs and 64 IRQ sources) at fc731000 OpenPIC timer frequency is 4.166666 MHz GMT Delta read from XPRAM: -300 minutes, DST: off via_calibrate_decr: ticks per jiffy = 249664 (1497989 ticks) Console: colour dummy device 80x25 Calibrating delay loop... 797.90 BogoMIPS Memory: 317028k available (1828k kernel code, 952k data, 284k init, 0k highmem) AGP special page: 0xd3fff000 Dentry-cache hash table entries: 65536 (order: 7, 524288 bytes) Inode-cache hash table entries: 32768 (order: 6, 262144 bytes) Mount-cache hash table entries: 8192 (order: 4, 65536 bytes) Buffer-cache hash table entries: 32768 (order: 5, 131072 bytes) Page-cache hash table entries: 131072 (order: 7, 524288 bytes) POSIX conformance testing by UNIFIX PCI: Probing PCI hardware Fixup res 1 (101) of dev 00:10.0: 400 -> 802400 Can't get bus-range for /[EMAIL PROTECTED]/[EMAIL PROTECTED] PCI->OF bus map: 0 -> 0 1 -> 0 6 -> 0 PCI:00:10.0: Resource 0: a4000000-a7ffffff (f=1208) PCI:00:10.0: Resource 2: a0000000-a0003fff (f=200) PCI:01:17.0: Resource 0: 80000000-8007ffff (f=200) PCI:01:1a.0: Resource 0: 80080000-80080fff (f=200) PCI:06:0f.0: Resource 0: f5200000-f53fffff (f=200) PCI:00:10.0: Resource 1: 00802400-008024ff (f=101) PCI:01:18.0: Resource 0: 80082000-80082fff (f=200) PCI:01:19.0: Resource 0: 80081000-80081fff (f=200) PCI:06:0e.0: Resource 0: f5000000-f5000fff (f=200) mediabay0: Registered KeyLargo media-bay mediabay0: powering down mediabay0: switching to 3 mediabay0: powering up mediabay0: enabling (kind:3) mediabay0: waiting reset (kind:3) mediabay0: waiting IDE reset (kind:3) mediabay0: waiting IDE ready (kind:3) mediabay0: up before IDE init Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Thermal assist unit using timers, shrink_timer: 200 jiffies Starting kswapd VFS: Diskquotas version dquot_6.4.0 initialized Journalled Block Device driver loaded PCI: Enabling device 00:10.0 (0086 -> 0087) aty128fb: Rage Mobility M3 (AGP) [chip rev 0x0] 8M 128-bit SDR SGRAM (1:1) Console: switching to colour frame buffer device 128x48 Registered "ati" backlight controller, level: 7/15 fb0: ATY Rage128 frame buffer device on PCI no framebuffer address found for /[EMAIL PROTECTED]/ATY,[EMAIL PROTECTED]/ATY,RageM3pB input0: Macintosh mouse button emulation pty: 256 Unix98 ptys configured block: 128 slots per queue, batch=32 RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port cfc at c00f5598 IN from bad port c000 at c00f56ac IN from bad port c100 at c00f56ac IN from bad port c200 at c00f56ac IN from bad port c300 at c00f56ac IN from bad port c400 at c00f56ac IN from bad port c500 at c00f56ac IN from bad port c600 at c00f56ac IN from bad port c700 at c00f56ac IN from bad port c800 at c00f56ac IN from bad port c900 at c00f56ac IN from bad port ca00 at c00f56ac IN from bad port cb00 at c00f56ac IN from bad port cc00 at c00f56ac IN from bad port cd00 at c00f56ac IN from bad port ce00 at c00f56ac IN from bad port cf00 at c00f56ac pmac_ide: enabling IDE bus ID 2 pmac_ide: enabling IDE bus ID 1 Registered ide 2 for media bay 0 hda: TOSHIBA MK1016GAP, ATA DISK drive hde: IOMEGA ZIP 250 ATAPI, ATAPI FLOPPY drive ide0 at 0xd888c000-0xd888c007,0xd888c160 on irq 19 ide2 at 0xd8894000-0xd8894007,0xd8894160 on irq 20 hda: Enabling Ultra DMA 4 ide_pmac: Set UDMA timing for mode 4, reg: 0x0c50038c hda: 19640880 sectors (10056 MB), CHS=19485/16/63, UDMA(66) Partition check: hda: [mac] hda1 hda2 hda3 hda4 hda5 hda6 hda7 hda8 hda9 hda10 hda11 hda12 hda13 loop: loaded (max 8 devices) eth0: GMAC at 00:30:65:7c:5d:de, driver v1.5k4 SCSI subsystem driver Revision: 1.00 request_module[scsi_hostadapter]: Root fs not mounted request_module[scsi_hostadapter]: Root fs not mounted Macintosh non-volatile memory driver v1.0 apm_emu: APM Emulation 0.5 initialized. usb.c: registered new driver usbdevfs usb.c: registered new driver hub PCI: Enabling device 01:18.0 (0000 -> 0002) usb-ohci.c: USB OHCI at membase 0xd5823000, IRQ 27 usb-ohci.c: usb-01:18.0, Apple Computer Inc. KeyLargo USB adb: starting probe task... usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected PCI: Enabling device 01:19.0 (0000 -> 0002) usb-ohci.c: USB OHCI at membase 0xd5825000, IRQ 28 usb-ohci.c: usb-01:19.0, Apple Computer Inc. KeyLargo USB (#2) usb.c: new USB bus registered, assigned bus number 2 hub.c: USB hub found hub.c: 2 ports detected usb.c: registered new driver usb_mouse usbmouse.c: v1.6:USB HID Boot Protocol mouse driver usb.c: registered new driver keyboard usbkbd.c: :USB HID Boot Protocol keyboard driver mice: PS/2 mouse device common for all mice NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 4096 buckets, 32Kbytes TCP: Hash tables configured (established 32768 bind 32768) Linux IP multicast router 0.06 plus PIM-SM NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. VFS: Mounted root (ext2 filesystem) readonly. Freeing unused kernel memory: 284k init 8k chrp 36k prep adb devices: [2]: 2 c3 [3]: 3 1 [7]: 7 1f ADB keyboard at 2, handler 1 Detected ADB keyboard, type ANSI. input1: ADB HID on ID 2:2.c3 input2: ADB HID on ID 7:7.1f ADB mouse at 3, handler set to 4 (trackpad) input3: ADB HID on ID 3:3.01 adb: finished probe task... hub.c: USB new device connect on bus2/1, assigned device number 2 input4: Logitech USB-PS/2 Optical Mouse on usb2:2.0 Adding Swap: 327672k swap-space (priority -1) i2c-core.o: i2c core module dmasound_pmac: Awacs/Screamer Codec Mfct: 1 Rev 3 PowerMac Screamer DMA sound driver rev 016 installed Core driver edition 01.06 : PowerMac Built-in Sound driver edition 00.07 Write will use 4 fragments of 32768 bytes as default Read will use 4 fragments of 32768 bytes as default usb.c: registered new driver audio audio.c: v1.0.0:USB Audio Class driver NET4: AppleTalk 0.18a for Linux NET4.0 eth0: PHY ID: 0x00406212 eth0: Found Broadcom BCM5201 PHY eth0: Link state change, phy_status: 0x782d eth0: Link up ! BCM5201/5221 aux_stat: 0x003e eth0: Full Duplex: 0, Speed: 100 autofs: called with bogus options ide-floppy driver 0.97.sv hde: 98304kB, 196608 blocks, 512 sector size hde: 244736kB, 239/64/32 CHS, 4096 kBps, 512 sector size, 2941 rpm hde: hde4 hde: 98304kB, 96/64/32 CHS, 4096 kBps, 512 sector size, 2941 rpm VFS: Disk change detected on device ide2(33,0) hde: hde4 VFS: Disk change detected on device ide2(33,0) hde: hde4 FAT: bogus logical sector size 8293 VFS: Can't find a valid FAT filesystem on dev 21:00. VFS: Disk change detected on device ide2(33,0) hde: hde4 VFS: Disk change detected on device ide2(33,0) hde: hde4 VFS: Can't find a HFS filesystem on dev 21:00. VFS: Disk change detected on device ide2(33,0) hde: hde4 -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
