On Wed, Jun 06, 2001 at 02:39:41PM -0700, Tom Rini wrote: > On Wed, Jun 06, 2001 at 03:27:40PM -0600, Mark K. Gardner wrote: > > [snip] > > 6) When prompted to set up booting from the hard disk, I escape to a > > shell and install yaboot: > > > > mkofboot --boot /dev/hda9 -m /usr/lib/yaboot/ofboot --root \ > > /dev/hda11 --partition 11 > > > > 7) Finally I reboot expecting to finish the Debian install. Instead > > MacOS boots. > > Because the nvram didn't get changed.
mkofboot by default alters nvram, unless he had bootfloppies older
then potato r2. however r2 yaboot/ybin may not be compatible with all
new machines. r3 is.
> Here's what _should_ work:
> Boot the debian install CD, but tell it root=/dev/hda11, so that it runs your
> install not the installer (or it _should_, I haven't used the CDs).
> After doing the normal configure/setup stuff, apt-get install yaboot, so
> you have yaboot/ybin, then configure /etc/yaboot.conf so that it has the
> bootstrap as hd:9 and root is hda11 (or so, this is from memory..) Also
> uncomment the nonvram bit and oh yeah, apt-get install powerpc-utils, so
> you'll have a good nvsetenv/et al, and run ybin. Then reboot and you
> should be able to go into linux. Since you said you had linux/os9.1/osx going
> before I'm assuming you've configured ybin/yaboot before. :)
>
> Something akin to all of this worked on my G4/466 a while back...
boot=/dev/hda9
device=hd:
partition=11
timeout=20
install=/usr/lib/yaboot/yaboot
magicboot=/usr/lib/yaboot/ofboot
image=/vmlinux
label=Linux
root=/dev/hda11
read-only
should work, but so should have the mkofboot command.
is this not the primary master IDE disk?
--
Ethan Benson
http://www.alaska.net/~erbenson/
pgp7RElh2j3gC.pgp
Description: PGP signature
