begin Thomas Krennwallner <[EMAIL PROTECTED]> wrote: > Joerg Sommer <[EMAIL PROTECTED]> writes: >> I had the same problem. Since an upgrade to 2.6.0-ben2 these problems >> are gone. > > Hm, before I run into the problem I had 2.4.22-4 running (yaboot > 1.3.10-2.1). Then I installed yaboot 1.3.11-1 but didn't run > ybin. Yesterday I tried 2.6.1-rc1 and 2.6.1-rc1-ben1. Neither of them > let me update nvram via ybin. I booted old 2.4.22-4 and tried to run > ybin with the same error.
Difficult. But this isn't a problem with yaboot. ybin calls nvsetenv which brings this error. So check if a newer powerpc-utils version then yours is available. Does nvsetenv work for you the first time? At me, I could call nvsetenv the first time without problems, but a second call brought an error. But all this is gone since the kernel upgrade. #v+ $ dpkg -l yaboot powerpc-utils Gew�nscht=Unbekannt/Installieren/R=Entfernen/P=S�ubern/Halten | Status=Nicht/Installiert/Config/U=Entpackt/Fehlgeschl. Konf./Halb install. |/ Fehler?=(keiner)/Halten/R=Neuinst. notw/X=beides (Status, Fehler: GRO�=schlecht) ||/ Name Version Beschreibung +++-==============-==============-============================================ ii yaboot 1.3.11-1 Yet Another Bootloader ii powerpc-utils 1.1.3-7 Various utilities for Linux/PowerPC $ uname -a Linux ibook 2.6.1-rc1-ben1 #1 Fri Jan 2 15:15:31 CET 2004 ppc GNU/Linux #v- What says ltrace (or strace)? Where occures the error? Joerg. end. -- Wenn du nur einen Hammer hast, sieht jedes Problem aus wie ein Nagel.
