"W.D. McKinney" wrote: > > Xeno Campanoli <[EMAIL PROTECTED]> wrote: > > > > > > Adding Swap: 173872k swap-space (priority -1) > > ne.c:v1.10 9/23/94 Donald Becker ([EMAIL PROTECTED]) > > NE*000 ethercard probe at 0x240: 00 50 ba a0 92 bb > > eth0: NE2000 found at 0x240, using IRQ 5. > > eth1: 3c509 at 0x320 tag 1, BNC port, address 00 a0 24 12 64 4b, IRQ 7. > > 3c509.c:1.16 (2.2) 2/3/98 [EMAIL PROTECTED] > > 3c59x.c:v0.99H 12Jun00 Donald Becker and others > > http://www.scyld.com/network/vortex.html > > eth2: 3Com 3c900 Cyclone 10Mbps TPO at 0xe400, 00:01:02:6b:43:33, IRQ 9 > > 8K byte-wide RAM 5:3 Rx:Tx split, autoselect/Autonegotiate interface. > > MII transceiver found at address 24, status 1809. > > Enabling bus-master transmits and whole-frame receives. > > eth3: 3Com 3c900 Cyclone 10Mbps TPO at 0xe800, 00:50:da:b4:4b:5a, IRQ > > 10 > > 8K byte-wide RAM 5:3 Rx:Tx split, autoselect/Autonegotiate interface. > > MII transceiver found at address 24, status 1809. > > Enabling bus-master transmits and whole-frame receives. > > Serial driver version 4.27 with no serial options enabled > > ttyS00 at 0x03f8 (irq = 4) is a 16550A > > ttyS01 at 0x02f8 (irq = 3) is a 16550A > > eth1: Setting Rx mode to 1 > > addresses. > > > > Now I noticed both have "Address 24", but other than that, I see no > > obvious potential problem, and even the latter isn't necessarily wrong. > > I don't really know. I guess it's back to Rubini. Any help or > > suggestions are appreciated. > > > > Per chance are you running lpd ? If so the printer is probably using IRQ 7 > and the module will load fine, but not work. Just a thought.
Hmm. Nope. And besides it works when there's only one 3c900. I'm not using 3c590s, and the kernel I'm using is 2.2.17 and Debian. > > I run SuSE with no problems with my 2 3c590's. > > /Dee
