Can anyone help me with the following installation problem on an Ultra 1 Creator?
When I try booting from the Potaro 2.2r4 install disk I get the the welcome screen asking me to choose whether my device is SCSI or IDE. After choosing 's' the linux kernel boots from the cdrom but I get the following scsi controller errors: esp0: IRQ 3,7e0 SCSI ID 7 Clk 40MHz CCF=8 TOut 167 NCR53C9XF(espfast) ESP: Total of 1 ESP hosts found, 1 actually in use. scsi0 : Sparc ESP366-HME scsi : 1 host. esp0: target 0 [period 100ns offset 15 20.00MHz FAST-WIDE SCSI-II] esp0: data bad parity detected. esp0: data bad parity detected. esp0: yieee, bytes_sent < 0! esp0: csz=0 fifocount=0 ecount=65464 esp0: use_sg=0 ptr=0000000000aa89 esp0: Forcing async for target 0 scsi0 : channel 0 target 0 lun 0 request sense failed, performing reset. SCSI bus is being reset for host 0 channel 0. esp0: Resetting scsi bus esp0: SCSI bus reset interrupt esp0: target 0 [period 100ns offset 15 20.00MHz FAST-WIDE SCSI-II] esp0: data bad parity detected. esp0: data bad parity detected. esp0: yieee, bytes_sent < 0! esp0: csz=0 fifocount=0 ecount=65464 esp0: use_sg=0 ptr=0000000000aa8b40 this_residual=0 esp0: Forcing async for target 0 scsi : aborting command due to timeout : pid 1, scsi0, channel 0, id 0, lun 0 0x 03 00 00 00 10 00 esp0: Aborting command Subsequently, after a few scsi resets only the cdrom is detected, but not the hard disk. Does anyone have any idea what might be going on here? I have been running Solaris 8 without any problems so I know the hard disk is still good. I have also recently upgraded to OpenBoot 3.25 in case that might be an issue. Thanks, David __________________________________________________ FREE voicemail, email, and fax...all in one place. Sign Up Now! http://www.onebox.com
