hi, i'm trying to test out a tape changer with an ultra 10, but it keeps giving me errors. i was able to control the changer for a little, but not anymore. it won't get past that scsi driver loading--it continually gives error messages and doesn't complete the boot, now.
this is a 2.4.18 kernel. 2.2.20 gave similar results. May 1 13:24:53 copper kernel: qlogicisp : new isp1020 revision ID (5) May 1 13:24:53 copper kernel: scsi0 : QLogic ISP1020 SCSI on PCI bus 03 device 20 irq 6277376 MEM base 0x1ff02808000 May 1 13:24:53 copper kernel: Vendor: ADIC Model: FastStor DLT Rev: 132D May 1 13:24:53 copper kernel: Type: Medium Changer ANSI SCSI revision: 02 May 1 13:24:53 copper kernel: scsi0 channel 0 : resetting for second half of retries. May 1 13:24:53 copper kernel: SCSI bus is being reset for host 0 channel 0. May 1 13:24:53 copper kernel: scsi : aborting command due to timeout : pid 4, scsi0, channel 0, id 3, lun 0 Inquiry 00 00 00 ff 00 May 1 13:24:53 copper last message repeated 25 times May 1 13:24:53 copper kernel: sunmouse: Successfully adjusted to 1200 baud. May 1 13:24:53 copper kernel: scsi : aborting command due to timeout : pid 4, scsi0, channel 0, id 3, lun 0 Inquiry 00 00 00 ff 00 May 1 13:24:53 copper kernel: scsi : aborting command due to timeout : pid 4, scsi0, channel 0, id 3, lun 0 Inquiry 00 00 00 ff 00 May 1 13:24:53 copper kernel: qlogicisp : unknown completion status 0x001e May 1 13:24:53 copper kernel: Attached scsi generic sg0 at scsi0, channel 0, id 2, lun 0, type 8 -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
