Ben Collins wrote:
I hooked up a serial terminal instead. The kernel booted, but after the
root file system was mounted there were no more messages, so I guess the
installation program output is going somewhere else.
If you connect a serial cable, you must disconnect the keyboard.
which I did (or used console=ttya), but the point was that I got all
the kernel messages on the serial terminal up to the point where the
root filesystem was mounted, but I did not see anything from dbootstrap.
Arne
--
Arne Nordmark Tel: +46 8 - 790 71 92
KTH/Mekanik Fax: +46 8 - 723 04 75
SE-100 44 STOCKHOLM Internet: [EMAIL PROTECTED]
Sweden
