lspci doesn't show anything I'm familair with as being sound either.. [EMAIL PROTECTED]:/etc/default# lspci 0000:00:00.0 Host bridge: Sun Microsystems Computer Corp. Schizo PCI Bus Module 0000:00:05.0 Bridge: Sun Microsystems Computer Corp. RIO EBUS (rev 01) 0000:00:05.1 Ethernet controller: Sun Microsystems Computer Corp. RIO GEM (rev 01) 0000:00:05.2 FireWire (IEEE 1394): Sun Microsystems Computer Corp. RIO 1394 (rev 01) 0000:00:05.3 USB Controller: Sun Microsystems Computer Corp. RIO USB (rev 01) 0000:00:06.0 SCSI storage controller: LSI Logic / Symbios Logic 53c875 (rev 37) 0000:00:06.1 SCSI storage controller: LSI Logic / Symbios Logic 53c875 (rev 37) 0000:01:00.0 Host bridge: Sun Microsystems Computer Corp. Schizo PCI Bus Module 0000:01:04.0 SCSI storage controller: QLogic Corp. QLA2200 64-bit Fibre Channel Adapter (rev 05)
However, I did pull open the case and look at the card. It's on a tiny slot about 1.5" long. The chip is marked with 'Crystal CS4231A-KQ CTAFUP0012' So I'm pretty sure it's crystal audio :] Now I'm just not sure how to configure it. <EOL> Tib On Sat, 23 Jul 2005, Jurij Smakov wrote: > On Sat, 23 Jul 2005, Tib wrote: > > > Had to run modprobe openprom to get this output, but I'm not sure exactly > > what to do now. The audio information doesn't look remotely useful. Now > > what should I do? > > Sorry, my mind was wandering a bit when I wrote my previous message :-). > As Blades have PCI buses, the device detection there uses PCI IDs, and not > information from prtconf. So, to include the support for your sound card > in discover1, you need to determine its PCI ID and the correct kernel > module. To get the ID you can use lspci, for example running lspci on my > (i386) machine displays the audio card as > > 0000:00:1f.5 Multimedia audio controller: Intel Corp. 82801CA/CAM AC'97 Audio > Controller (rev 02) > > You can then run lspci -n, the relevant output will look like that: > > 0000:00:1f.5 0401: 8086:2485 (rev 02) > > The PCI ID for this card is then 8086:2485. The mappings between PCI IDs > and kernel module which discover1 will load to make it work are stored in > /lib/discover/pci.lst. I can check whether there is an entry for my card > there (note the removed colon in the PCI ID): > > bash$ grep 80862485 /lib/discover/pci.lst > 80862485 sound i810_audio 82801CA/CAM AC'97 Audio > Controller > bash$ > > So, when discover1 finds this card, it will load i810_audio module. For > your card such a mapping is most likely absent. Once you determine the PCI > ID and the needed module, you can add a line for it to > /lib/discover/pci.lst and check whether it works. If everything works out, > submit a wishlist bug against discover1-data with this information. > > Best regards, > > Jurij Smakov [EMAIL PROTECTED] > Key: http://www.wooyd.org/pgpkey/ KeyID: C99E03CC > > > -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
