Hi, all. Last night, I downloaded and installed Etch (latest image from the D-I page at debian.org) on an SS20 with a Sun Lance network card. When I reboot after the first part of the install, I get the message that 'eth0 is deprecated' or something like that. When I do ifconfig, all I see is the loopback address.
The network was configured correctly during the install, although it did take 2 tries to find dhcp on my adsl router/ hub, this suggested to me that the card was a bit slow. Could it possibly be that the right module isn't getting loaded at boot? Alternatively, is it possible to slow the network bit of the boot process, to give the card sufficient time to get an ip address from the router? Any thoughts appreciated. Many thanks, Chris. CJH ANDREW [EMAIL PROTECTED]
