Jurij Smakov wrote:
On Sun, 28 May 2006, Hamish Greig wrote:
On Sunday 28 May 2006 13:44, Wenton L. Davis wrote:
Trying to install on an E4500, the install boots from the CD, sterts
running, tries to detect the CDROM using several different IDE drivers,
but this system is purely SCSI. I get stuck in this rescan for CDROM?
<YES> <NO> thing. Out of ideas and very frustrated.
Wenton L. Davis
ALt F2; hit enter; modprobe esp
As long as esp is the driver on the 4500 that is. It is the driver on my
e3000, I had to use the same method to install.
Hamish
If the machines have esp SCSI controllers, I'd appreciate if you could
test the daily etch installer builds, from
www.d.o/devel/debian-installer.
The installer have been fixed up to detect esp properly, so if it does
not work for some reason, I'm sure d-i team would appreciate a report.
Best regards,
Jurij Smakov [EMAIL PROTECTED]
Key: http://www.wooyd.org/pgpkey/ KeyID: C99E03CC
Works beautifully!
I did go ahead and modprobe sd_mod and sr_mod, just to be sure.
Next problems, I can't get X11 to configure, mostly because I can't
figure out who to scan the bus for the graphics card ID. (It's not a
PCI bus.) And, I'm not sure now to check if the mouse has a driver
loaded. I can look in /proc/devices, and I find a line: "13 input"
which I expect to handle the mouse.... right?
Wenton L. Davis
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
