Jurij Smakov wrote:
On Sun, Feb 25, 2007 at 10:45:37PM -0500, Robert Reif wrote:
I'm trying to compile a kernel on etch without success. I first tried a
2.6.21-rc1 and it failed to boot because the image was too large. I
next tried the debian source in /usr/src/linux-source-2.6.18.tar with
the same results. Both were configured with the config from /boot.
For sparc32 you need to strip the kernel of non-essential parts in
order for it to fit into the space reserved for it. It goes
approximately like this:
cp /boot/vmlinuz-2.6.18-4-sparc32 vmlinux.gz
gzip -d vmlinux.gz
strip -R .comment -R .note -K sun4u_init -K _end -K _start vmlinux
gzip -9 vmlinux
mv vmlinux.gz /boot/vmlinuz-2.6.18-4-sparc32
Best regards,
Thanks, I'll give it a try tonight. Shouldn't make-kpkg or dpkg
--install .deb do this for me?
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
