I also had problems getting the kernel to load correctly over network. My solution to this was to connect the sparc over a serial console to some other box. Provided that the terminal on the other side is working correctly, the installation menus will work ok, although they'll be a bit sluggish at 9600 bps. To force the OPB into serial console mode, you need to boot without a keyboard connected.
You may also need to give the command output-device without parameters in OPB before trying to do that, since otherwise OPB may ignore the fact that there's no keyboard, and still go into video mode. Tell us your results! /Didrik Madheden On 17/12/2007, Vera Mickael <[EMAIL PROTECTED]> wrote: > Hi, > > I try to install etch on a sunblade 150, I reached the stage > where I can see the first installer menu. For those who > encountered the same problems as me, I used the boot command: > > boot net video=atyfb:off > > My problem is that the menu isn't displayed correctly, > instead of colors on the border of the menu, special > caracters are displayed. The screen's background is white > and caracters are printed in black. I can't see which > element is selected, there is no element highlighted. > It's not possible to install this way. > > Is there an option to pass to the installer ? Is it possible > to disable ncurses ? > > Thanks, > Mickaël > > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] -----BEGIN 2ROT13 MESSAGE----- Low Bitrate Netlabel: <http://flb.gg8.se/> Blog: <http://gameboygenius.8bitcollective.com/> SKRIVA på Lysator. Ditt Ahrvid-fria alternativ: <http://lists.lysator.liu.se/mailman/listinfo/korkek?SKRIVA?> Sätt på ett par flipflops, vippa på rumpan och gör det här till en minnesvärd sommar! -----END 2ROT13 MESSAGE-----
