Hi Hermann, On Tue, 2017-12-05 at 15:20 +0100, Hermann Lauer wrote: > Hi Frans, > > On Tue, Dec 05, 2017 at 02:43:48PM +0100, Frans van Berckel wrote: > > Silo does not ask for a device, it just installs. Rebooting goes > > into a > > Hmm - priority=low is set in the installer?
Within Silo, the install label, theres no priority set. The expert mode does priority=low. > > disk errors and searching for the dhcp network device. > > > > Rebooting with command: boot > > > > Bad magic number in disk label > > Can't open disk label package > > Sounds like the sun partition table is not ok after installation - > what > does "fdisk /dev/sda" tell you ? ~ # fdisk /dev/sda Welcome to fdisk (util-linux 2.30.2). Changes will remain in memory only, until you decide to write them. Be careful before using the write command. The old ext2 signature will be removed by a write command. Device does not contain a recognized partition table. Created a new partition 1 of type 'Linux native' and of size 136.7 GiB. Created a new partition 2 of type 'Linux swap' and of size 47.1 MiB. Created a new partition 3 of type 'Whole disk' and of size 136.7 GiB. Created a new Sun disklabel. Command (m for help): p Disk /dev/sda: 136.7 GiB, 146810536448 bytes, 286739329 sectors Geometry: 255 heads, 63 sectors/track, 17848 cylinders Units: sectors of 1 * 512 = 512 bytes Sector size (logical/physical): 512 bytes / 512 bytes I/O size (minimum/optimal): 512 bytes / 512 bytes Disklabel type: sun Device Start End Sectors Size Id Type Flags /dev/sda1 0 286631729 286631730 136.7G 83 Linux native /dev/sda2 286631730 286728119 96390 47.1M 82 Linux swap u /dev/sda3 0 286728119 286728120 136.7G 5 Whole disk Command (m for help): q - To be clear, these are just created, by exec fdisk. > Does "hexdump -C /dev/sda" (or sdb) contain stuff like: Within the installer theres no udeb package which contains hexdump. Do you know any alternative? Thanks, Frans van Berckel