try "Protocol" instead of Protocal roland
Ilia Lobsanov wrote: >Have you tried restarting X? > >ilia. > >On Thu, 2002-01-24 at 12:45, McNeill Kirkpatrick wrote: > >>It's still not moving >> >>here is the mouse section from my XF86Config-4 file >> >>Section "InputDevice" >> Identifier "Configured Mouse" >> Driver "mouse" >> Option "Device" "/dev/input/mice" >> Option "Protocal" "ImPS/2" >> Option "Emulate3Buttons" "true" >> Option "ZAxisMapping" "4 5" >>EndSection >> >>I just installed usbmgr, and it seems to work >>output when I unplug and plug in the mouse: >>usb.c: USB disconnect on device 4 >>hub.c: USB new device connect on bus1/2, assigned device number 5 >>usb.c: USB device 5 (vend/prod 0x46d/0xc002) is not claimed by any >>active driver. >> >>I am pretty sure I compiled usb-uhci directly into the kernel, yet the >>mouse just won't move, with either gpm or with X. >> >>On Thu, 2002-01-24 at 11:17, Ilia Lobsanov wrote: >> >>>Check if you have usb-uhci module loaded... and install usbmgr. >>> >>>ilia. >>> >>>On Thu, 2002-01-24 at 11:53, McNeill Kirkpatrick wrote: >>> >>>>Ok, I'm running sid and I'm trying to get it to recognize my usb mouse, >>>>I recompiled my kernel(2.4.17) with input core support for mice, I had >>>>to run MAKEDEV input manually, that created the /dev/input/mice. When I >>>>use this device however, X starts fine,(no cannot access device errors) >>>>but I cannot move the mouse. It just sits in the middle of the >>>>screen.Any suggestions? >>>> >>>> >>>>-- >>>>To UNSUBSCRIBE, email to [EMAIL PROTECTED] >>>>with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] >>>> >>> >>> >>>-- >>>To UNSUBSCRIBE, email to [EMAIL PROTECTED] >>>with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] >>> >> >>-- >>To UNSUBSCRIBE, email to [EMAIL PROTECTED] >>with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] >> > > > -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
