Bonjours, j'ai sur ma debian un disk sata qui fonctionne parfaitement.
Le seul probl�me est que je ne peux pas le monter au boot, il semblerai
que sata_promise se charge apres le montage des disques.
Est-ce que quelqu'un a une id�e.
Puis-je essayer de charger sata_promise avant de monter les disques?
un extrait de dmesg:
EXT3-fs: mounted filesystem with ordered data mode.
Adding 1092376k swap on /dev/hda6. Priority:-1 extents:1
EXT3 FS on hda7, internal journal
Real Time Clock Driver v1.12
hdc: ATAPI 40X DVD-ROM CD-R/RW CD-MRW drive, 8192kB Cache, UDMA(44)
Uniform CD-ROM driver Revision: 3.20
Capability LSM initialized
SCSI subsystem initialized
ieee1394: Initialized config rom entry `ip1394'
ohci1394: $Rev: 1203 $ Ben Collins <[EMAIL PROTECTED]>
PCI: Setting latency timer of device 0000:00:0d.0 to 64
ohci1394: fw-host0: OHCI-1394 1.1 (PCI): IRQ=[21]
MMIO=[e4084000-e40847ff] Max Packet=[2048]
forcedeth.c: Reverse Engineered nForce ethernet driver. Version 0.25.
PCI: Setting latency timer of device 0000:00:04.0 to 64
eth0: forcedeth.c: subsystem: 01462:570c bound to 0000:00:04.0
libata version 1.02 loaded.
sata_promise version 0.92
ata1: SATA max UDMA/133 cmd 0xEC85A200 ctl 0xEC85A238 bmdma 0x0 irq 18
ata2: SATA max UDMA/133 cmd 0xEC85A280 ctl 0xEC85A2B8 bmdma 0x0 irq 18
ata1: dev 0 cfg 49:2f00 82:74eb 83:7fea 84:4023 85:74e9 86:3c02 87:4023
88:203f
ata1: dev 0 ATA, max UDMA/100, 160836480 sectors (lba48)
ata1: dev 0 configured for UDMA/100
scsi0 : sata_promise
ohci1394: fw-host0: SelfID received outside of bus reset sequence
ata2: no device found (phy stat 00000100)
ata2: thread exiting
scsi1 : sata_promise
Vendor: ATA Model: HDS722580VLSA80 Rev: 1.02
Type: Direct-Access ANSI SCSI revision: 05
merci pour toutes infos
Fr�d�ric
