Hallo, verzweifelt versuche ich auf meinem Notebook (altes MMX 200) unter sarge einen eigenen Kernel zu kompilieren, scheitere bei der Konfiguration. Der Standard-2.2.10 und Knoppix erkennen die Karte jedoch problemlos.
Ein spezielles 2.4.24 Problem? Problem aus dmesg: Linux version 2.4.24carlos ([EMAIL PROTECTED]) (gcc version 3.3 (Debian)) #1 Sun Feb 8 18:56:23 CET 2004 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009f800 (usable) BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved) BIOS-e820: 00000000000f0c00 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 0000000006000000 (usable) BIOS-e820: 00000000ffff0c00 - 0000000100000000 (reserved) [...] Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI ISAPNP enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16) Linux Kernel Card Services 3.1.22 options: [pci] [cardbus] [pm] Intel ISA PCIC probe: not found. ds: no socket drivers loaded! Zum Vergleich die entsprechenden Zeilen wenn Knoppix bootet: Linux version 2.4.22-xfs ([EMAIL PROTECTED]) (gcc version 2.95.4 20011002 (Debian prerelease)) #1 SMP Fr Sep 19 17:55:45 CEST 2003 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009f800 (usable) BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved) BIOS-e820: 00000000000f0c00 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 0000000006000000 (usable) BIOS-e820: 00000000ffff0c00 - 0000000100000000 (reserved) [...] apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16) Linux Kernel Card Services 3.1.22 options: [pci] [cardbus] [pm] PCI: Assigned IRQ 11 for device 00:0a.0 PCI: Assigned IRQ 9 for device 00:0a.1 Yenta IRQ list 0498, PCI irq11 Socket status: 30000006 Yenta IRQ list 0498, PCI irq9 Socket status: 30000010 cs: IO port probe 0x0c00-0x0cff: clean. cs: IO port probe 0x0820-0x08ff: clean. cs: IO port probe 0x0800-0x080f: clean. cs: IO port probe 0x0100-0x04ff: excluding 0x100-0x107 0x220-0x22f 0x278-0x27f 0x300-0x307 0x388-0x38f 0x398-0x39f 0x3f8-0x3ff 0x4d0-0x4d7 cs: IO port probe 0x0a00-0x0aff: clean. cs: memory probe 0xa0000000-0xa0ffffff: clean. xirc2ps_cs.c 1.31 1998/12/09 19:32:55 (dd9jn+kvh) Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI ISAPNP enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A eth0: Xircom: port 0x2e0, irq 3, hwaddr 00:80:C7:1E:3B:E1 ttyS01 at port 0x02f8 (irq = 3) is a 16450 eth0: media 10BaseT, silicon revision 1 usb.c: registered new driver usbdevfs usb.c: registered new driver hub usb-uhci.c: $Revision: 1.275 $ time 18:09:24 Sep 19 2003 usb-uhci.c: High bandwidth mode enabled PCI: Enabling device 00:01.2 (0000 -> 0001) PCI: Assigned IRQ 11 for device 00:01.2 usb-uhci.c: USB UHCI at I/O 0xfcc0, IRQ 11 usb-uhci.c: Detected 2 ports usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected usb-uhci.c: v1.275:USB Universal Host Controller Interface driver usbdevfs: remount parameter error parport0: PC-style at 0x278 (0x678) [PCSPP,TRISTATE] parport0: irq 7 detected Adding Swap: 129020k swap-space (priority -1) eth0: media 10BaseT, silicon revision 1 Die Module sind vorhanden, an der PCMCIA-Konfig habe ich nichts ge�ndert, die Linux Kernel Card Services sind in der gleichen Version 3.1.22. lspci gibt in beiden F�llen das gleiche aus: 00:00.0 Host bridge: Intel Corp. 430TX - 82439TX MTXC (rev 01) 00:01.0 Bridge: Intel Corp. 82371AB/EB/MB PIIX4 ISA (rev 01) 00:01.1 IDE interface: Intel Corp. 82371AB/EB/MB PIIX4 IDE (rev 01) 00:01.2 USB Controller: Intel Corp. 82371AB/EB/MB PIIX4 USB (rev 01) 00:01.3 Bridge: Intel Corp. 82371AB/EB/MB PIIX4 ACPI (rev 01) 00:02.0 VGA compatible controller: Neomagic Corporation NM2160 [MagicGraph 128XD] 00:0a.0 CardBus bridge: Texas Instruments PCI1131 (rev 01) 00:0a.1 CardBus bridge: Texas Instruments PCI1131 (rev 01) IMHO ist die CardBus bridge der PCMCIA controller, right? carlos:/home/peter/Pcmcia/faulty# dpkg -L kernel-image-2.4.24carlos | grep drive r.*pcmcia /lib/modules/2.4.24carlos/kernel/drivers/char/pcmcia /lib/modules/2.4.24carlos/kernel/drivers/char/pcmcia/serial_cs.o /lib/modules/2.4.24carlos/kernel/drivers/char/pcmcia/synclink_cs.o /lib/modules/2.4.24carlos/kernel/drivers/net/pcmcia /lib/modules/2.4.24carlos/kernel/drivers/net/pcmcia/xirc2ps_cs.o /lib/modules/2.4.24carlos/kernel/drivers/net/pcmcia/xircom_cb.o /lib/modules/2.4.24carlos/kernel/drivers/net/pcmcia/xircom_tulip_cb.o /lib/modules/2.4.24carlos/kernel/drivers/pcmcia /lib/modules/2.4.24carlos/kernel/drivers/pcmcia/ds.o /lib/modules/2.4.24carlos/kernel/drivers/pcmcia/i82365.o /lib/modules/2.4.24carlos/kernel/drivers/pcmcia/pcmcia_core.o /lib/modules/2.4.24carlos/kernel/drivers/pcmcia/yenta_socket.o carlos:/home/peter/Pcmcia/faulty# Etwas ratlos... Peter -- Peter Weiss / [EMAIL PROTECTED] Sun Microsystems GmbH / Sonnenallee 1, D-85551 Kirchheim-Heimstetten (+49 89) 46008 2947 / mobil 0177/ 60 40 121 -- Haeufig gestellte Fragen und Antworten (FAQ): http://www.de.debian.org/debian-user-german-FAQ/ Zum AUSTRAGEN schicken Sie eine Mail an [EMAIL PROTECTED] mit dem Subject "unsubscribe". Probleme? Mail an [EMAIL PROTECTED] (engl)
