Ola Amigos, gostaria de
configurar uma fita dat, no sarge, mas olha so ela nao montou em nst0 nem st0
nao estou conseguindo nada...
alguem tem alguma lus...
o linux esta instalado ja na scsi e o que
vem abaixo eh
cat /proc/scsi/scsi
scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER,
Rev 6.2.36
<Adaptec aic7880 Ultra SCSI adapter>
aic7880: Ultra Wide Channel A, SCSI Id=7, 16/253 SCBs
<Adaptec aic7880 Ultra SCSI adapter>
aic7880: Ultra Wide Channel A, SCSI Id=7, 16/253 SCBs
(scsi0:A:0): 40.000MB/s transfers (20.000MHz, offset
8, 16bit)
Vendor: FUJITSU Model: M2949ESP SUN9.0G Rev: 2848
Type: Direct-Access ANSI SCSI revision: 02
(scsi0:A:6): 10.000MB/s transfers (10.000MHz, offset 15)
Vendor: ARCHIVE Model: Python 04106-XXX Rev: 7350
Type: Sequential-Access ANSI SCSI revision: 02
Vendor: SDR Model: GEM200 Rev: 2
Type: Processor ANSI SCSI revision: 02
scsi0:A:0:0: Tagged Queuing enabled. Depth 8
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
SCSI device sda: 17689267 512-byte hdwr sectors (9057 MB)
Partition check:
/dev/scsi/host0/bus0/target0/lun0: p1 p2 < p5 >
Vendor: FUJITSU Model: M2949ESP SUN9.0G Rev: 2848
Type: Direct-Access ANSI SCSI revision: 02
(scsi0:A:6): 10.000MB/s transfers (10.000MHz, offset 15)
Vendor: ARCHIVE Model: Python 04106-XXX Rev: 7350
Type: Sequential-Access ANSI SCSI revision: 02
Vendor: SDR Model: GEM200 Rev: 2
Type: Processor ANSI SCSI revision: 02
scsi0:A:0:0: Tagged Queuing enabled. Depth 8
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
SCSI device sda: 17689267 512-byte hdwr sectors (9057 MB)
Partition check:
/dev/scsi/host0/bus0/target0/lun0: p1 p2 < p5 >
agradeco a colaboracao de todos
