On 5/18/07, Luis Clemente <[EMAIL PROTECTED]> wrote:
Olá Max,Então, uso o ETCH com o kernel 2.6.18-4 default. Vou te mandar as saídas do dmesg no momento da detecção do device pnp na inicialização do Debian e depois com a reinstalação do módulo manualmente com os comandos rmmod e modprobe. via pnp: QLogic Fibre Channel HBA Driver ACPI: PCI Interrupt 0000:05:01.0[A] -> GSI 73 (level, low) -> IRQ 201 qla2xxx 0000:05:01.0: Found an ISP2312, irq 201, iobase 0xf882c000 qla2xxx 0000:05:01.0: Configuring PCI space... qla2xxx 0000:05:01.0: Configure NVRAM parameters... qla2xxx 0000:05:01.0: Verifying loaded RISC code... qla2xxx 0000:05:01.0: Firmware image unavailable. qla2xxx 0000:05:01.0: Firmware images can be retrieved from: ftp://ftp.qlogic.com/outgoing/linux/firmware/. qla2xxx 0000:05:01.0: Failed to initialize adapter ACPI: PCI interrupt for device 0000:05:01.0 disabled ACPI: PCI interrupt for device 0000:05:01.0 disabled reinstalação manual do módulo qla2xxx QLogic Fibre Channel HBA Driver PCI: Enabling device 0000:05:01.0 (0150 -> 0153) ACPI: PCI Interrupt 0000:05:01.0[A] -> GSI 73 (level, low) -> IRQ 201 qla2xxx 0000:05:01.0: Found an ISP2312, irq 201, iobase 0xf8840000 qla2xxx 0000:05:01.0: Configuring PCI space... qla2xxx 0000:05:01.0: Configure NVRAM parameters... qla2xxx 0000:05:01.0: Verifying loaded RISC code... qla2xxx 0000:05:01.0: Allocated (412 KB) for firmware dump... qla2xxx 0000:05:01.0: Waiting for LIP to complete... qla2xxx 0000:05:01.0: LOOP UP detected (2 Gbps). qla2xxx 0000:05:01.0: Topology - (F_Port), Host Loop address 0xffff scsi4 : qla2xxx qla2xxx 0000:05:01.0: QLogic Fibre Channel HBA Driver: 8.01.07-k1 QLogic QLA2340 - 133MHz PCI-X to 2Gb FC, Single Channel ISP2312: PCI-X (133 MHz) @ 0000:05:01.0 hdma+, host#=4, fw=3.03.20 IPX Vendor: HITACHI Model: OPEN-V*16 Rev: 2114 Type: Direct-Access ANSI SCSI revision: 02
É bem estranho, manualmente parece não dar problema... Faz o download do firmware apropriado do site da qlogic[1], depois copia o binário (a menos que queira baixar o fonte (os .C) e compilar...) para /lib/firmware. A propósito, carregando "manualmente" funciona? 1 - http://support.qlogic.com/support/product_resources.asp?id=583
