Ola Sandro,
Eu mudei ip da wireles para um outro ip e tambem fiz a verificação da chave
digitada e o problema ainda persiste.
sudo ifconfig
eth0 Link encap:Ethernet Endereço de HW 00:1d:ba:03:70:82
inet end.: 10.0.39.136 Bcast:10.0.39.255 Masc:255.255.255.0
endereço inet6: fe80::21d:baff:fe03:7082/64 Escopo:Link
UP BROADCASTMULTICAST MTU:1500 Métrica:1
RX packets:17822 errors:0 dropped:0 overruns:0 frame:0
TX packets:12158 errors:0 dropped:0 overruns:0 carrier:0
colisões:0 txqueuelen:1000
RX bytes:11909034 (11.3 MiB) TX bytes:1851828 (1.7 MiB)
IRQ:16
lo Link encap:Loopback Local
inet end.: 127.0.0.1 Masc:255.0.0.0
endereço inet6: ::1/128 Escopo:Máquina
UP LOOPBACKRUNNING MTU:16436 Métrica:1
RX packets:201 errors:0 dropped:0 overruns:0 frame:0
TX packets:201 errors:0 dropped:0 overruns:0 carrier:0
colisões:0 txqueuelen:0
RX bytes:202037 (197.3 KiB) TX bytes:202037 (197.3 KiB)
wlan0 Link encap:Ethernet Endereço de HW 00:21:5d:a0:fc:68
inet end.: 10.0.39.135 Bcast:10.0.39.255 Masc:255.255.255.0
endereço inet6: fe80::221:5dff:fea0:fc68/64 Escopo:Link
UP BROADCASTRUNNING MULTICAST MTU:1500 Métrica:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:144 errors:0 dropped:0 overruns:0 carrier:0
colisões:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:16646 (16.2 KiB)
emyg...@emygdio:~$ ping 10.0.39.81
PING 10.0.39.81 (10.0.39.81) 56(84) bytes of data.
>From 10.0.39.135 icmp_seq=2 Destination Host Unreachable
>From 10.0.39.135 icmp_seq=3 Destination Host Unreachable
^C
--- 10.0.39.81 ping statistics ---
5 packets transmitted, 0 received, +2 errors, 100% packet loss, time 4016ms
, pipe 2
2010/6/4 Sandro Wambier <[email protected]>
> Veja se vc digitou a chave errada, e outra, mude o IP da sua wlan0 para
> outro diferente de eth0.
>
> 2010/6/4 Rodrigo Emygdio <[email protected]>
>
>
>> Pessoal,
>>
>> Recentemente retornei a utilizar o debian lenny. Consegui fazer o OS
>> reconhecer minha placa wireless recompilando o kernel e configurar-la. Porem
>> a placa reconhece o AP mas não conecta na rede segue abaixo so detelhes
>>
>>
>> emyg...@emygdio:~$ sudo iwconfig
>> lo no wireless extensions.
>>
>> eth0 no wireless extensions.
>>
>> wlan0 IEEE 802.11abgn ESSID:"cis_terreo_01"
>> Mode:Managed Frequency:2.437 GHz Access Point:
>> 00:12:17:AA:53:33
>> Bit Rate=1 Mb/s Tx-Power=15 dBm
>> Retry long limit:7 RTS thr:off Fragment thr:off
>> Encryption key:*************************************
>> Power Management:off
>> Link Quality=70/70 Signal level=-34 dBm
>> Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
>> Tx excessive retries:0 Invalid misc:0 Missed beacon:0
>>
>>
>> emyg...@emygdio:~$ sudo ifconfig
>>
>> eth0 Link encap:Ethernet Endereço de HW 00:1d:ba:03:70:82
>> inet end.: 10.0.39.135 Bcast:10.0.39.255 Masc:255.255.255.0
>> endereço inet6: fe80::21d:baff:fe03:7082/64 Escopo:Link
>> UP BROADCASTRUNNING MULTICAST MTU:1500 Métrica:1
>> RX packets:6389 errors:0 dropped:0 overruns:0 frame:0
>> TX packets:5746 errors:0 dropped:0 overruns:0 carrier:0
>> colisões:0 txqueuelen:1000
>> RX bytes:5614745 (5.3 MiB) TX bytes:810272 (791.2 KiB)
>> IRQ:16
>>
>> lo Link encap:Loopback Local
>> inet end.: 127.0.0.1 Masc:255.0.0.0
>> endereço inet6: ::1/128 Escopo:Máquina
>> UP LOOPBACKRUNNING MTU:16436 Métrica:1
>> RX packets:10 errors:0 dropped:0 overruns:0 frame:0
>> TX packets:10 errors:0 dropped:0 overruns:0 carrier:0
>> colisões:0 txqueuelen:0
>> RX bytes:728 (728.0 B) TX bytes:728 (728.0 B)
>>
>> wlan0 Link encap:Ethernet Endereço de HW 00:21:5d:a0:fc:68
>> inet end.: 10.0.39.135 Bcast:10.0.39.255 Masc:255.255.255.0
>> endereço inet6: fe80::221:5dff:fea0:fc68/64 Escopo:Link
>> UP BROADCASTRUNNING MULTICAST MTU:1500 Métrica:1
>> RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>> TX packets:58 errors:0 dropped:0 overruns:0 carrier:0
>> colisões:0 txqueuelen:1000
>> RX bytes:0 (0.0 B) TX bytes:8860 (8.6 KiB)
>>
>> emyg...@emygdio:~$ cat /etc/resolv.conf
>> #nameserver 10.1.1.1
>> nameserver 10.0.39.81
>>
>> emyg...@emygdio:~$ sudo route
>> Tabela de Roteamento IP do Kernel
>> Destino Roteador MáscaraGen. Opções Métrica Ref Uso
>> Iface
>> localnet * 255.255.255.0 U 0 0 0
>> eth0
>> localnet * 255.255.255.0 U 0 0 0
>> wlan0
>> link-local * 255.255.0.0 U 1000 0 0
>> eth0
>> default 10.0.39.81 0.0.0.0 UG 0 0 0
>> wlan0
>> default 10.0.39.81 0.0.0.0 UG 0 0 0
>> eth0
>>
>> emyg...@emygdio:~$ ping google.com
>> ping: unknown host google.com
>>
>> emyg...@emygdio:~$ ping 10.0.39.81
>> PING 10.0.39.81 (10.0.39.81) 56(84) bytes of data.
>> From 10.0.39.135 icmp_seq=9 Destination Host Unreachable
>> From 10.0.39.135 icmp_seq=10 Destination Host Unreachable
>> From 10.0.39.135 icmp_seq=11 Destination Host Unreachable
>> ^C
>> --- 10.0.39.81 ping statistics ---
>> 13 packets transmitted, 0 received, +3 errors, 100% packet loss, time
>> 12081ms
>>
>>
>> So consigo enxergar a rede quando conecto o cabo como no exemplo do ping a
>> baixo:
>>
>> emyg...@emygdio:~$ ping 10.0.39.81
>> PING 10.0.39.81 (10.0.39.81) 56(84) bytes of data.
>> 64 bytes from 10.0.39.81: icmp_seq=1 ttl=128 time=0.700 ms
>> 64 bytes from 10.0.39.81: icmp_seq=2 ttl=128 time=0.498 ms
>> 64 bytes from 10.0.39.81: icmp_seq=3 ttl=128 time=0.580 ms
>> ^C
>> --- 10.0.39.81 ping statistics ---
>> 3 packets transmitted, 3 received, 0% packet loss, time 1998ms
>> rtt min/avg/max/mdev = 0.498/0.592/0.700/0.087 ms
>>
>>
>> Alguem saberia me dizer o que esta acontecendo. No Ubuntu funcionva
>> normal.
>>
>> Desde ja agradeço
>>
>> Obrigado.
>>
>>
>>
>
