Boa noite pessoal,
Tenho um note Aspire 5251-1096, placa rede wireless está usando o driver
ath9k, placa de rede convecional está usando driver tg3, minhas placas no
lspci:
02:00.0 Ethernet controller: Broadcom Corporation NetLink BCM57780 Gigabit
Ethernet PCIe (rev 01)
08:00.0 Network controller: Atheros Communications Inc. AR928X Wireless
Network Adapter (PCI-Express) (rev 01)
Os dados do dmesg:
Wlan0
root@jose:~# dmesg | grep wlan
[ 13.527224] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 49.204349] wlan0: direct probe to AP 00:21:91:6f:40:aa (try 1)
[ 49.207399] wlan0: direct probe responded
[ 49.207404] wlan0: authenticate with AP 00:21:91:6f:40:aa (try 1)
[ 49.209626] wlan0: authenticated
[ 49.209649] wlan0: associate with AP 00:21:91:6f:40:aa (try 1)
[ 49.212359] wlan0: RX AssocResp from 00:21:91:6f:40:aa (capab=0x431
status=0 aid=1)
[ 49.212362] wlan0: associated
[ 49.212725] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[ 59.468137] wlan0: no IPv6 routers present
root@jose:~#
Eth0
root@jose:~# dmesg | grep eth
[ 1.467096] eth0: Tigon3 [partno(BCM57780) rev 57780001] (PCI Express)
MAC address 00:23:5a:64:43:20
[ 1.467100] eth0: attached PHY driver [Broadcom BCM57780]
(mii_bus:phy_addr=200:01)
[ 1.467103] eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] TSOcap[1]
[ 1.467105] eth0: dma_rwctrl[76180000] dma_mask[64-bit]
[ 13.317616] ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 14.177135] tg3: eth0: Link is down.
root@jose:~#
Os dados do comando usando iwconfig conectado:
wlan0 IEEE 802.11bgn ESSID:"Leonor"
Mode:Managed Frequency:2.437 GHz Access Point: 00:21:91:6F:40:AA
Bit Rate=54 Mb/s Tx-Power=20 dBm
Retry long limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:on
Link Quality=52/70 Signal level=-58 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
O que está muito estranho que conectado a placa de rede normal conecta no
msn usando o Empathy com telepathy-haze, porém quando eu uso rede wireless
não consegue conectar, já tentei usando o telepathy-butterfly, mas acontece
o mesmo erro, se precisarem de mais alguma informa para tentarem ajudar, só
avisar, de preferência com os comandos.
