Ola Amigos, Eu espetei outra placa de rede aqui no debian potato! :)
Inseri o modulo e fiz as configs no /etc/network/interfaces ficando assim: Debian:~# cat /etc/modules # /etc/modules: kernel modules to load at boot time. # # This file should contain the names of kernel modules that are # to be loaded at boot time, one per line. Comments begin with # a #, and everything on the line after them are ignored. rtl8139 ne2k-pci ps.: Uma placa eh uma Realtek8139 (rtl8139.o) e a outra um Realtek8129(AS) (ne2k-pci). Debian:~# cat /etc/network/interfaces # /etc/network/interfaces -- configuration file for ifup(8), ifdown(8) # The loopback interface iface lo inet loopback # Config da eth0 iface eth0 inet static address 192.168.151.2 netmask 255.255.255.0 network 192.168.151.0 broadcast 192.168.151.255 gateway 192.168.151.1 # config da eth1 iface eth1 inet static address 192.168.151.3 netmask 255.255.255.0 network 192.168.151.0 broadcast 192.168.151.255 gateway 192.168.151.1 Parece estar tudo correto nao ?? Inclusive as placas sao detectadas. Veja: eth0: RealTek RTL8139 Fast Ethernet at 0x1800, IRQ 5, 00:e0:7d:c5:1b:54. eth1: RealTek RTL-8029 found at 0x1440, IRQ 10, 00:00:21:FC:4E:E4. A tabela de rotas tmb parece estar certa: Debian:~# route -n Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 192.168.151.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0 192.168.151.0 0.0.0.0 255.255.255.0 U 0 0 0 eth1 0.0.0.0 192.168.151.1 0.0.0.0 UG 0 0 0 eth0 Debian:~# Pra desencargo de consiencia (mesmo sabendo que nao tem nada a ver) eu coloquei a rota default pra eth1 tmb! Debian:~# route add default gw 192.168.151.1 dev eth1 Debian:~# route -n Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 192.168.151.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0 192.168.151.0 0.0.0.0 255.255.255.0 U 0 0 0 eth1 0.0.0.0 192.168.151.1 0.0.0.0 UG 0 0 0 eth1 0.0.0.0 192.168.151.1 0.0.0.0 UG 0 0 0 eth0 Debian:~# Eh mesmo assim eu pingo a 192.168.151.3 (que eh a eth1) e nao responde o ping. E nem a eth2 consegue pingar ninguem da rede! :/ Algeum sabe pq isso ta acontecendo ?? Esqueci de fazer alguma coisa ?? Obrigado. t+ [ ]'s Use Your Hadrion WebMail too! Access: <A href=http://www.hadrion.com.br/>http://www.hadrion.com.br</A> Doubts? <A href=mailto:[EMAIL PROTECTED]>[EMAIL PROTECTED]</A> ________________________________________________ This mail was sent by Hadrion WebMail 1.0
