Tengo un problemita con la red. Esta es la conf. que tengo: # This file describes the network interfaces available on your system # and how to activate them. For more information, see interfaces(5).
# The loopback network interface auto lo iface lo inet loopback # The primary network interface allow-hotplug eth0 auto eth0 iface eth0 inet static address 10.33.20.2 network 10.33.20.0 netmask 255.255.255.0 broadcast 10.33.20.255 gateway 10.33.20.254 dns-search uci.cu dns-nameservers 10.0.0.3 10.0.0.4 Uso Debian Testing El problema es el siguiente: Cuando enciendo la PC, todos los servicios se restablecen de manera normal, peor ya despues de 5 mins., la red se me cae. El mensaje que me deja dmesg es el siguiente: ********************************************************************** 16.305015] lo: Disabled Privacy Extensions [ 16.305015] ADDRCONF(NETDEV_UP): eth0: link is not ready [ 17.433210] eth0: Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX [ 17.433257] eth0: 10/100 speed: disabling TSO [ 17.433422] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready [ 18.667232] lp0: using parport0 (interrupt-driven). [ 18.685643] ppdev: user-space parallel port driver [ 21.171849] warning: `avahi-daemon' uses 32-bit capabilities (legacy support in use) [ 25.562554] [drm] Initialized drm 1.1.0 20060810 [ 25.566551] ACPI: PCI Interrupt 0000:00:02.0[A] -> GSI 16 (level, low) -> IRQ 16 [ 25.566551] PCI: Setting latency timer of device 0000:00:02.0 to 64 [ 25.566551] [drm] Initialized i915 1.6.0 20060119 on minor 0 [ 28.486471] eth0: no IPv6 routers present [ 94.242390] ADDRCONF(NETDEV_UP): eth0: link is not ready [ 98.546638] eth0: Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX [ 98.546700] eth0: 10/100 speed: disabling TSO [ 98.546889] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready [ 110.831629] eth0: no IPv6 routers present [ 146.001787] ADDRCONF(NETDEV_UP): eth0: link is not ready [ 150.973574] eth0: Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX [ 150.973632] eth0: 10/100 speed: disabling TSO [ 150.973871] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready [ 161.829014] eth0: no IPv6 routers present *********************************************************************************** Pero a veces no coge la red, se queda pasmado y no hay forma de que vuelva. ¿Qué podría ser esto? ¿Estoy obligado a darle un /etc/init.d/networking restart cada 5 mins? (Le puse un .sh en el cron para quitarme esto) saludos -- "Los virus en Linux son como los extraterrestres;sabemos que existen pero nadie ha visto uno.." Kriptopolis... Marcos Ortiz Valmaseda Linux User # 418229
