|
Lo que te dice Alexander es lo correcto, montas la
particion, chroot, compruebas el lilo.conf que este correcto y ejecutas lilo y
deber�a arrancar; pero m�s cosas:
Dices que has recompilado el kernel, �con el kernel
viejo no te deja arrancar?
Esto lo cuento para que m�s o menos sepas por donde
tirar, o por lo menos es lo que yo har�a:
Repasa el lilo.conf
detalladamente.
Mira si la partici�n est�, con
el cfdisk por ejemplo (a mi me desaparecieron una vez ^_^")
Especifica lo de que Knoppix no
te da acceso, que error te da y esas cosas.
Y esto de culturilla general, cada letra del LILO significa algo:
(/usr/share/doc/lilo)
L <error> ... The
first stage boot loader has been loaded and started,
but it can't load the second stage boot loader. The two-digit error codes indicate the type of problem. (See also section "Disk error codes".) This condition usually indicates a media failure or a geometry mismatch (e.g. bad disk parameters, see section "Disk geometry"). LI The first stage boot loader was able to load the second stage boot loader, but has failed to execute it. This can either be caused by a geometry mismatch or by moving /boot/boot.b without running the map installer. LIL The second stage boot loader has been started, but it can't load the descriptor table from the map file. This is typically caused by a media failure or by a geometry mismatch. LIL? The second stage boot loader has been loaded at an incorrect address. This is typically caused by a subtle geometry mismatch or by moving /boot/boot.b without running the map installer. LIL- The descriptor table is corrupt. This can either be caused by a geometry mismatch or by moving /boot/map without running the map installer. LILO All parts of LILO have been successfully loaded. Suerte para recuperar esos datos.
|
Title: Mensaje
- [.lilo] No puedo Arrancar Vicente Lopez
- Re: [.lilo] No puedo Arrancar Alexander
- kekio
