J'ai un scaner Agfa Snapscan 310 SCSI connect� sur un carte adaptec AHA1505.
J'ai essay� de le faire march� en suivant les instructions donn�es sur
L�alinux.
Les modules sg.o et aha152x.o sont biens pr�sents (ls
/lib/modules/`uname -r`/scsi).
J'ai ajout� les lignes suivantes au fichier /etc/conf.module:
alias scsi_hostadapter aha152x
options aha152x aha152x=0x140,9
Lorsque je tape la commande "modprobe aha152x" j'obtient le message:
/lib/modules/2.2.14-15mdk/scsi/aha152x.o: init_module: P�riph�rique ou
ressource occup�
J'ai �galement essay� "cat /proc/scsi/scsi":
Attached devices: none
Voici la partie du fichier isapnp.conf qui concerne la carte scsi (du moins
je pense):
Card 2: (serial identifier 71 7a 41 b0 59 05 15 90 04)
# Vendor Id ADP1505, Serial Number 2051125337, checksum 0x71.
# Version 1.0, Vendor version 1.1
# ANSI string -->Adaptec AVA-1505AE <--
#
# Logical device id ADP1505
# Device supports I/O range check register
#
# Edit the entries below to uncomment out the configuration required.
# Note that only the first value of any range is given, this may be changed
if required
# Don't forget to uncomment the activate (ACT Y) when happy
(CONFIGURE ADP1505/2051125337 (LD 0
# ANSI string -->SCSI Controller<--
# Compatible device id ADP1530
# Multiple choice time, choose one only !
# Start dependent functions: priority preferred
# Logical device decodes 16 bit IO address lines
# Minimum IO base address 0x0140
# Maximum IO base address 0x0140
# IO base alignment 32 bytes
# Number of IO addresses required: 32
# (IO 0 (SIZE 32) (BASE 0x0140) (CHECK))
# IRQ 9, 10, 11 or 12.
# High true, edge sensitive interrupt
# (INT 0 (IRQ 9 (MODE +E)))
# Start dependent functions: priority acceptable
# Logical device decodes 16 bit IO address lines
# Minimum IO base address 0x0340
# Maximum IO base address 0x0340
# IO base alignment 32 bytes
# Number of IO addresses required: 32
# (IO 0 (SIZE 32) (BASE 0x0340) (CHECK))
# IRQ 9, 10, 11 or 12.
# High true, edge sensitive interrupt
# (INT 0 (IRQ 9 (MODE +E)))
# End dependent functions
(NAME "ADP1505/2051125337[0]{SCSI Controller }")
# (ACT Y)
))
# End tag... Checksum 0x00 (OK)
# Returns all cards to the "Wait for Key" state
(WAITFORKEY)
Merci d'avance
Guillaume
P.S: je ne trouve pas les "HOWTO" sur mon syst�me (mandrake 7). Ou sont-il
install�s?
