Je n'arrive toujours pas � utiliser une carte memoire sur une Mandrake
9.1 . Pour info cette carte fontionne sur XP Millenium (h� oui) et sur
Debian sans probl�me. Elle format� en vfat c'est du moins le syst�me de
fichier que Debian reconnait en faisant mount -t auto ...
Pour les amoureux des probl�mes je donne ici un apercu des messages du
noyau qui pourraient permettre d'identifier le probl�me:
Linux version 2.4.21-0.18mdk ([EMAIL PROTECTED]) (gcc version 3.2.2 (Mandrake Linux
9.1 3.2.2-3mdk)) #1 Wed Jun 4 12:38:37 MDT 2003
SCSI subsystem driver Revision: 1.00
Mounted devfs on /dev
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-uhci.c: $Revision: 1.275 $ time 13:06:08 Jun 4 2003
usb-uhci.c: High bandwidth mode enabled
PCI: Found IRQ 9 for device 00:07.2
usb-uhci.c: USB UHCI at I/O 0xa000, IRQ 9
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
usbdevfs: remount parameter error
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
USB Mass Storage support registered.
hub.c: new USB device 00:07.2-2, assigned address 2
scsi1 : SCSI emulation for USB Mass Storage devices
usb-uhci.c: interrupt, status 3, frame# 1662
Vendor: Model: Rev:
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0
SCSI device sda: 62720 512-byte hdwr sectors (32 MB)
sda: Write Protect is off
/dev/scsi/host1/bus0/target0/lun0:scsi1: ERROR on channel 0, id 0, lun 0, CDB: Read
(10) 00 00 00 00 00 00 00 08 00
Current sd08:00: sense key Volume Overflow
I/O error: dev 08:00, sector 0
scsi1: ERROR on channel 0, id 0, lun 0, CDB: Read (10) 00 00 00 00 00 00 00 08 00
Nota: le message ci-dessus apparait une trentaine de fois, il y donc
reconnaissnce et tentative de montage mais sans succ�s....
Vendor: Linux Model: scsi_debug Rev: 0004
Type: Direct-Access ANSI SCSI revision: 03
Attached scsi disk sdb at scsi2, channel 0, id 0, lun 0
SCSI device sdb: 16384 512-byte hdwr sectors (8 MB)
/dev/scsi/host2/bus0/target0/lun0: unknown partition table
usb.c: registered new driver serial
usbserial.c: USB Serial support registered for Generic
usbserial.c: USB Serial Driver core v1.4
usb-uhci.c: interrupt, status 2, frame# 851
scsi1: ERROR on channel 0, id 0, lun 0, CDB: Read (10) 00 00 00 00 00 00 00 08 00
Current sd08:00: sense key Volume Overflow
I/O error: dev 08:00, sector 0
usb.c: USB disconnect on device 00:07.2-2 address 2
hub.c: new USB device 00:07.2-2, assigned address 3
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 3
Device not ready. Make sure there is a disc in the drive.
VFS: Disk change detected on device 08:00
SCSI device sda: 62720 512-byte hdwr sectors (32 MB)
usb-uhci.c: interrupt, status 3, frame# 1149
sda: Write Protect is off
/dev/scsi/host1/bus0/target0/lun0: I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 62712
I/O error: dev 08:00, sector 62712
I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 0
ldm_validate_partition_table(): Disk read failed.
I/O error: dev 08:00, sector 0
VFS: Disk change detected on device 08:00
SCSI device sda: 62720 512-byte hdwr sectors (32 MB)
sda: Write Protect is off
/dev/scsi/host1/bus0/target0/lun0: p1
udf: registering filesystem
usb.c: USB disconnect on device 00:07.2-2 address 3
voila si quelqu'un peut me donner une id�e sur la mani�re de monter
correctement ce p�riph�rique je suis preneur. Je rappelle qu'il
fonctionne parfaitement avec d'autres syst�me et m�me Linux (Debian)
merci
--
"""""
""""" (' o o `)
---ooO---------Ooo-----------ooO---(_)---Ooo---
o n'ayez plus peur - montrez-vous o
Vous souhaitez acquerir votre Pack ou des Services MandrakeSoft?
Rendez-vous sur "http://www.mandrakestore.com";.
Foire Aux Questions de la liste : http://mdk.mondelinux.org
