Hi Andrew, will update those 2 comments in the V2, thanks.
> -----Original Message-----
> From: Andrew Rybchenko <[email protected]>
> Sent: Monday, May 22, 2023 3:02 PM
> To: Ori Kam <[email protected]>; Bill Zhou <[email protected]>; Slava
> Ovsiienko <[email protected]>; NBU-Contact-Thomas Monjalon
> (EXTERNAL) <[email protected]>; Aman Singh
> <[email protected]>; Yuying Zhang <[email protected]>;
> Ferruh Yigit <[email protected]>; Olivier Matz <[email protected]>
> Cc: [email protected]; Raslan Darawsheh <[email protected]>
> Subject: Re: [PATCH v1 1/3] ethdev: add flow item for RoCE infiniband BTH
>
> On 5/17/23 20:06, Ori Kam wrote:
> > Hi Bill,
> >
> >> -----Original Message-----
> >> From: Bill Zhou <[email protected]>
> >> Sent: Thursday, May 11, 2023 10:55 AM
> >> Subject: [PATCH v1 1/3] ethdev: add flow item for RoCE infiniband BTH
>
> RoEC should be added devtools/words-case.txt IB as well.
>
> >>
> >> IB(InfiniBand) is one type of networking used in high-performance
> >> computing with high throughput and low latency. Like Ethernet, IB
> >> defines a layered protocol (Physical, Link, Network, Transport
> >> Layers). IB provides native support for RDMA(Remote DMA), an
> >> extension of the DMA that allows direct access to remote host memory
> >> without CPU intervention. IB network requires NICs and switches to
> >> support the IB protocol.
> >>
> >> RoCE(RDMA over Converged Ethernet) is a network protocol that allows
> >> RDMA to run on Ethernet. RoCE encapsulates IB packets on ethernet and
> >> has two versions, RoCEv1 and RoCEv2. RoCEv1 is an ethernet link layer
> >> protocol, IB packets are encapsulated in the ethernet layer and use
> >> ethernet type 0x8915. RoCEv2 is an internet
>
> ethernet -> Ethernet (4 times above)
>
> >> layer protocol, IB packets are encapsulated in UDP payload and use a
> >> destination port 4791, The format of the RoCEv2 packet is as follows:
> >> ETH + IP + UDP(dport 4791) + IB(BTH + ExtHDR + PAYLOAD + CRC)
> >>
> >> BTH(Base Transport Header) is the IB transport layer header, RoCEv1
> >> and RoCEv2 both contain this header. This patch introduces a new RTE
> >> item to match the IB BTH in RoCE packets. One use of this match is
> >> that the user can monitor RoCEv2's CNP(Congestion Notification
> >> Packet) by matching BTH opcode 0x81.
> >>
> >> This patch also adds the testpmd command line to match the RoCEv2
> >> BTH. Usage example:
> >>
> >> testpmd> flow create 0 group 1 ingress pattern
> >> eth / ipv4 / udp dst is 4791 / ib_bth opcode is 0x81
> >> dst_qp is 0xd3 / end actions queue index 0 / end
> >>
> >> Signed-off-by: Dong Zhou <[email protected]>
> >> ---
> >
> > Acked-by: Ori Kam <[email protected]>
>
> Acked-by: Andrew Rybchenko <[email protected]>
>
